1999 528I rear passenger door wont unlock or open from inside ,window is also down and wont close any ideas on how to open door and remove inside door panel

SOURCE: Front passenger door won't open.

you may need to get a slim jim to open the door to make the repairs -jeff please rate

ZJ Limited

• 17989 Answers
• Posted on Jul 27, 2009

SOURCE: Diagram for removing door panel

Check this documents, in spanish, but you can find graphics to help in there:
- WJ-2002-Cherokee-Service-Manual-PDF-23-Carroceria (Body - Page 23-36 Fig. 14 and next)
- WJ-2002-Cherokee-Service-Manual-PDF-08S-Elevalunas-Electricos (Electric Windows)

Good luck!!!

SOURCE: The rear left passenger door window power lift

the power window on 2000 chev suburban is stuck down. i removed the door pannel and the motor works but it appears the wiring on the pulley is not right any info how to remove.or repair that system?

SOURCE: passenger door panel removal. it seems like the

Hi!!

Here is a blow out diagram of the door panel for your vehicle.



If you feel you need step by step instruccions with illustrations to R&R the door panel, click the following link http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c1528006f79c

Don't forget to rate this post!! Good Luck!!!

SOURCE: i want to remove passenger

Hi,
Hi!!

Here is a little information on how window regulator works. Also step by step instruccions on how to remove and install the window glass.

Door Glass & Regulator Power Windows
Diagnosis & Testing
When the rear window lockout feature is enabled, the circuit is open and no voltage is supplied to the rear window switches. When the feature is not enabled, the circuit is connected to battery positive voltage. If this circuit is shorted to ground when the lockout feature is not enabled, the PWR WDO circuit breaker may cycle continuously OFF/ON until, either the lockout switch is pressed to open the circuit, or the circuit breaker is permanently damaged. All windows may be partially or totally inoperative while the fault is present.
Inspect for aftermarket devices which could affect the operation of the system. Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom. Faulty electrical connections or wiring may be the cause of intermittent conditions.
Removal & Installation
Window Motor & Regulator

1. Position window approximately half way down in the door.
2. Remove the interior trim panel.
3. Remove the water deflector.
4. Tape the window to door frame to prevent it from moving.
5. Remove the three front door window regulator motor screws.
6. Disconnect the electrical connector from the window regulator motor.
7. Remove front side door window regulator motor.
8. To install, reverse removal procedure.

1. Remove the front door pull cup screws and pull cup from the front door trim panel.
2. Disconnect the electrical connectors from the front door power window control switch.
3. Remove the front door window control switch using a small, flat-bladed tool at the side of the switch.
4. To install, reverse removal procedure.

1. Remove the rear door pull cup from the rear door trim panel.
2. Disconnect the electrical connectors from the power window control switch.
3. Remove the rear door window control switch from the pull cup using a small, flat-bladed tool at the side of the power window control switch to release the power window control switch retainer.
4. Remove the power window control switch from the rear door pull cup.
5. To install, reverse removal procedure.