Belt diagram for 2008 pacifica 3.8 serpentine routing

well it did not fall off
so pencil and paper draw out yours.
takes 5min work, no service manual to buy.
it depends on what 3 engines is there now.

seen here. (USA only car) exports ive no clue.

Im assuming it is a 3.5 lt

if the belt is still on the car take a picture to know the routing of it. there should be a decal under the hood somewhere that shows the belt routing.

Have a look at this page here.
Can you help with this Ford 2006 Mustang question posted on FixYa

Pop the hood of the car and locate the serpentine belt routing diagram. The diagram on the 2003 Chevrolet Impala is on top of the fan shroud. The diagram will be a picture of all of the accessory pulleys and how the serpentine belt is routed among the pulleys. This diagram will give you the exact direction for routing the new belt onto the pulleys. If you cannot find a serpentine belt routing diagram, take a notepad and pen and draw out the exact routing diagram of the old belt across the pulleys.

2 Locate the serpentine belt tensioner. It is located below the alternator on the left front side of the engine. The tensioner on the 3.4 liter, 3.5 liter and the 3.9 liter engines will require a 3/8 ratchet to release the belt tensioner. The 3.8 liter engine will require a ratchet and a 15 mm socket for the belt tensioner. Rotate the belt tensioner clockwise to loosen and remove the belt from the belt tensioner pulley.

3 Slide the old belt from the belt tensioner pulley. Remove the belt from the remaining pulleys and pull the belt from the engine compartment.

4 Route the new belt across the crankshaft pulley first. The crankshaft pulley is the big pulley on the bottom of the engine in the center. Then route the serpentine belt across the remaining pulleys as directed by the serpentine belt routing diagram. Leave the belt tensioner pulley for last.

5 Rotate the belt tensioner clockwise again to relieve the tension and slide the new belt across the top of the belt tensioner pulley. Release the belt tensioner and the belt will tighten up as the tensioner applies pressure to the belt. Make sure the new belt is properly seated in all the pulleys.

6 Crank the engine and inspect the belt again to make sure that it stays seated in the pulleys.

Read more: How to Replace a Serpentine Belt on a 2003 Chevrolet Impala ' eHow.co.uk http://www.ehow.co.uk/how_6120665_replace-belt-2003-chevrolet-impala.html#ixzz1Yi6QLAjb

here it is

At Autozone and probably others, the packaging for the belt has the routing diagram on the box.

here are a couple diagrams...




If you need anything else, let me know.

First, you need to have the diagram for how the belt is routed when you replace it.

Serpentine routing diagram...


Here is a link to a video on how to replace the serpentine belt. I hope it helps!

http://www.wonderhowto.com/how-to-inspect-replace-cars-serpentine-belt-267229/

First, you need to have the diagram for how the belt is routed when you replace it.
Serpentine routing diagram...



Here is a link to a video on how to replace the serpentine belt. I hope it helps!

http://www.wonderhowto.com/how-to-inspect-replace-cars-serpentine-belt-267229