My overhead info panel has stopped lighting up also. Could these be related at all?
SOURCE: 1995 dodge intrepid
The ignition switch is faulty if the gauges and dash lights will not come on, change the fuses first. Transmission fluid and filter change needed. Differential gear oil change also needed.
SOURCE: fuse panel 1995 dodge intrepid
The fuse diagram is on the panel cover, if you didn't figure that out by now.
SOURCE: instrument panel
If you take off the cover around the steering colum there should be a wire connected above your blinker switch if its not all the way pushed in tac ,speed and other lights will not work.
SOURCE: I have a 2002 Dodge Intrepid ES 3.5L and on the way home this
try to disconnect the neg and pos charge to the battery almost every newer car has a computer in it it may be that the computer just needs to be reset
SOURCE: front cv axle 1995 dodge intrepid
Naturally you need to remove the tire then the brake caliper. After the brake caliper is removed then you need to remove the 34mm axle nut that is inside the hub. After that is removed then you can remove the hub. Becareful not to damage the hub seal on the back or you will have to buy a new hub (100 or more). Then you need to remove the strut knuckle assembly. Once the knuckle assembly is removed then you can pull the CV axle. Take care the inner CV housing is held in place by an inner snap ring. You will probably have to pry off the inner housing. Once the axle is off then install the new axle (if you buy complete axle). Make sure if you are doing both that you take care which side you are installing. I made that mistake and double the work. Slide the new axle on the spline and make sure it is seated completely. Then put back together the reverse of removal.
49 views
Usually answered in minutes!
×