Question about 2003 Hyundai Tiburon

Open Question

I need wire colors for 4 sensors on my 2003 hyundai tiburon 2.7, 1 mass air flow, 2 IAC motor, 3 TPS, 4 Cam sensor

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
dustyboner
  • 364 Answers

SOURCE: mass air flow sensor

<SOHC, Federal - Non Turbo,Canada - Non Turbo>

1d0cd9b.jpg ---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------=====================================================================================================================================

<California - DOHC Non Turbo, Turbo>


c4dfca0.jpg

Posted on Oct 18, 2008

Ad
  • 19 Answers

SOURCE: 1997 buick lasabre custom high idle, transmission, stalling

had same problem i would check the Idel Air Valve and also check all of your vaccum hose lines makeing sure there are no cracks or splits in rubber connectors if there is repair immediatelt because over time they start to dammage the internal parts fo the engine and if youve replace tps mass air etc. sounds like a vaccum hose problem

Posted on Feb 10, 2009

c17hydro
  • 2989 Answers

SOURCE: MASS AIR FLOW SENSOR REPLACEMENT & DIAGRAMS

Very easy for the Mass Air Flow Sensor....it is in the duct between the throttle body and the air filter box. Just unclamp the tube and remove the old and replace with the new.

13d0cec.jpg

On your pack....I need the engine size.


Posted on Mar 26, 2009

SOURCE: 2003 Hyundai Sonata with 4

P0301 - Cylinder 1 Misfire Detected.

Possible Causes:
- Improper spark plug at cylinder #1
- Insufficient compression at cylinder #1
- Incorrect fuel pressure
- The injector circuit is open or shorted at cylinder #1
- Fuel injector #1 may be faulty
- Intake air leak at cylinder

Possible Solutions:
- Perform Injector Service
- Replaced Spark Plug #1
- Replaced Injector #1
- Replaced Ignition Coil #1

Being you have a heavy gas smell I would look into the injectors. If injector #1 is over producing it can cause a misfire. Test your compression and fuel pressure.

Posted on Jan 17, 2011

SOURCE: PO301 code on Hyundai Sonata. Replaced wires,

P0301 - Cylinder 1 Misfire Detected.


Possible Causes:
- Improper spark plug at cylinder #1
- Insufficient compression at cylinder #1
- Incorrect fuel pressure
- The injector circuit is open or shorted at cylinder #1
- Fuel injector #1 may be faulty
- Intake air leak at cylinder


Possible Solutions:
- Perform Injector Service
- Replaced Spark Plug #1
- Replaced Injector #1
- Replaced Ignition Coil #1

Posted on Jan 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda revs up but will not get out of low gear, what's wrong? Worked fine before changing motors


It never hurts to triple check, All conections, all sensors, top off fluids, Check transmission shift solenoids, Vehicle Speed Sensor(VSS), Wiring to all Modules. ECM/PCM, TCM, Power Disribution Center, Fuses and Relays, All harness grounds, Engine Speed Sensor, Throttle Position Sensor(TPS), IS FUEL Injected? Idle Air Control(IAC), Mass Air Flow Sensor(MAS), Manifold Absolute Pressure(MAP) sensor. Manifold air pressure sensor. Torque converter, Coolant Temperature sensor, ETC..... Everything.

Mar 08, 2017 | Honda Cars & Trucks

2 Answers

2003 f/250 5.4 I've replaced the cat ,Mac,tps,IAC,fuel filter ,plugs ,and packs it iddles but when you push the accelerator it stalls spits & sputters


Check your mass air flow sensor and all vacuum hoses for leaks, your mass air flow sensor is located somewhere on the intake hose between the air filter box and manifold. Maybe loose wires maybe bad airflow sensor, could just be dirty, could even be timing advance or other sensors. Read codes from computer and go from there but likely something simple.

Feb 16, 2017 | 2003 Ford F250

1 Answer

Need to know how many sensor. is on my transmission.. 2003 Pontiac Montana v 6 .. can you show me picture where transmission control solenoid goes?


There are 12 common sensors and 10 internal sensors. The most common that often fail (MAP), (TPS), (CAM), (IGN), (CRANK) MAP is your mass air flow which is located at the beginning of your air intake, TPS is the throttle body position sensor, the CAM is the cam shaft position sensor (transmission), IGN ignition position sensor and the CRANK sensor is located near the bottom driver side front

Oct 26, 2013 | 2003 Pontiac Montana

1 Answer

My 2003 hyundai tiburon 2L iddles at a steady 4000 rpm and wont iddle down. How do I fix this??


There r 2 cables on a gt 6 speed that r located at the top of the engine in back.. Do not touch the rear cable unless ur tibrron is shifted hard. The front cable is ur drift idle, theyre 2 nuts tightend den to secure it at a certian level , untighten the nuts and simply ajust the 2 nuts backwards do the cable isnt so tight and allows the engine to drop idle wen accelerater isnt pressed. Then do the same to the rear cable(2nd) cable untill u have ur tibron sounding just right..only sol_tion

Nov 03, 2012 | 2003 Hyundai Tiburon

4 Answers

P0101 code for check engine light.. possible solutions???


Diagnostic Test Code (DTC) P0101 has a generic description of "Mass or volume air flow circuit range/performance problem". This can be caused by several things including:
> Dirty air filter
> Air leak in air intake system
> Contaminated, deterriorated or damaged Mass Air Flow Sensor
> Poor electrical connections at the Engine Control Module, the Mass Air Flow (MAF) sensor or the Throttle Position Sensor (TPS)
> Faulty MAF or TPS

You should check your air filter and air intake system visually and correct any obvious defects/leaks first.

If a visual inspection does not turn up the cause, then you will need a scan tool capable of reading sensor data to verify the function of the MAF and TPS. You will also need proper electrical diagnostic equipment to verify the integrity of the circuits and continue with diagnosis.

Sep 11, 2011 | 2005 Kia Rio

1 Answer

Jumpy throttle still, i had dealership run diagnostics on it. they said to replace tps sensor and mass airflow sensor. they wanted an arm and a leg so i went and got the parts from advance auto parts and...


yeah its pretty easy to change the mass air flow sensor. find the mass air flow sensor on your air intake an un screw it a n disconect the cable an replace. the tps...... if you are looking at the motor (standing in front of front bumber looking at the engine top right side of motor you will see the throttle sensor an all you have to do is un screw and put new one in. it should just fit right in with no problem.

Jun 01, 2010 | 2005 Hyundai Tucson

2 Answers

I have a 03 tiburon gt 2.7 and when you hit the gas the engine revs up to about 3100rpm for about 10 secs the drops down to about 1500 and surges up and down form 1500rpm to 2000rpm then it will idle...


its gonna be your clutch i had the same problem, when i floor it the rpms would go high then drop and take off i replaced it and it runs fine know

Feb 13, 2010 | 2003 Hyundai Tiburon

2 Answers

I have a 2004 hyundai tiburon and everytime i start it the throttle is like stuck and just keeps going until it hits redline. i pulled the codes and it said throttle position sensor so i replaced it along...


In order for a fuel injected engine to ran way up to redline,it has to be a combination of

air
Clean Mass Air Flow senor and connector with CRC Mass Air Flow sensor or electrical part cleaner.

fuel,
Check fuel pressure at fuel rail

ECU


incorrect / grounded / damage wiring on the TPS.


Throttle cable linkage
Smooth throttle movement?


Carpet under the gas paddle (like Toyota?)


My best is a grounded and short TPS.

Dec 09, 2009 | 2004 Hyundai Tiburon

1 Answer

4 cylinder motor


http://www.analogstereo.com/pdf/om/hyundai_tiburon_owners_manual_2003.pdf
note_icon.gif Mark all wiring and hoses to avoid misconnection. Inspection the timing belt before removing the cylinder head. Turn the crankshaft pulley so that the No. 1 piston is at top dead center
1. Disconnect the neagative terminal from the battery 2. Remove the engine cover. . Drain the engine coolant. Remove the radiator cap to speed draining. 4. Remove the intake air hose and air cleaner assembly. (1) Disconnect the AFS connector. (2) Disconnect the breather hose from air cleaner hose. (3) Remove the intake air hose and air cleaner. 5. Remove the upper radiator hose (A) and lower radiator hose (B). 6. Remove the heater hoses 7. Remove the engine wire harness connectors and wire harness clamps from the cylinder head and the intake manifold. (1) OCV(Oil Control Valve) connector (A). (2) Oil temperature sensor connector (B). (3) ECT (Engine Coolant Temperature) sensor (C) connector. (4) Ignition coil connector (D). (5) TPS (Throttle Position Sensor) connector (A). (6) ISA (Idle Speed Actuator) connector (B). (7) CMP (Camshaft Position Sensor) connector (A). (8) Four fuel injector connectors (B). (9) Knock sensor connector (C).

May 27, 2008 | 2003 Hyundai Tiburon

Not finding what you are looking for?
2003 Hyundai Tiburon Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...