Head bolts here
http://www.speedwayautoparts.com/Torque%20Table%20T1.pdf
SOURCE: Cylinderhead bolts torque settings
According to my haynes manual for Landrover 200tdi, G - S reg,1989-1998 it goes as follows,
Stage 1:- Tighten all bolts to 30lb ft or 40Nm then
Stage 2:- Angle tighten a further 60 degrees then
Stage 3:- Angle tighten a further 60 degrees again.
SOURCE: hyundai elantra 1.6GLS J2 torque settings
dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm
SOURCE: need torque settings for big end and main bearing
big end - stage one 18-22 Nm. stage 2 40-50 degrees
main bearings stage 1 20 Nm stage 2 90 degrees
5,202 views
Usually answered in minutes!
×