Https://s25.postimg.org/q53i6unfj/wiper.jpg
Click on the link.
Found this fuse, hope it helps?
SOURCE: Winshield washer motor does not run
These days, most windshield washer pumps are mounted to the bottom of the washer fluid reservoir. Where’s that, you ask? Well, 
you know that spout you pour the fluid into—the one that disappears into nowhere? Well, the reservoir is actually 
located inside the front fender between the bumper and the front wheel.
To replace the pump, you will have to jack up the vehicle, remove the front wheel and then remove the inner fender liner.
SOURCE: 2005 dodge noen cam sensor
I own a 2002 neon sxt and recently had to replace the cam sensor it should be in the same place.
look on the right side of the motor you should see it. it'll have a small wire harness that clips in the top and its fastend with 4 bolts. Oh and take the battery out before you do it it makes it a lot easier.
Hope this helps.
SOURCE: where is the camshaft sensor located on a 2005
should be located on one side and below the valve cover near the very front or the very rear of the engine... these things are easy to point out then to try and describe... hope that gives you a starting point
cheers
SOURCE: locating and replacing a camshaft sensor in a 2005 dodge neon
this is a very very simple procedure. you do not need pics. there is a sensor located at the end of the engine on the far side from the belts. at the top. it has a plug with two wires in it. just remove the two 10mm bolts un hook the plug and reverse the process to reinstall. if you have a factory intake you may have to remove it to access this sensor. just the intake tube.
SOURCE: 2005 dodge neon sxt how many motor mounts
Hi I'm litoshop on your vehicle you have 5 mounts front left side, front right side, lower strut rear of engine,upper strut right side and transaxle rear left side good luck if this information has been helpful please let use know thank you
you know that spout you pour the fluid into—the one that disappears into nowhere? Well, the reservoir is actually located inside the front fender between the bumper and the front wheel.
To replace the pump, you will have to jack up the vehicle, remove the front wheel and then remove the inner fender liner.
525 views
Usually answered in minutes!
×