2000 Dodge Stratus Logo

Related Topics:

J
Jen P Posted on Sep 25, 2017
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Where is the Mass Air Flow Sensor located on a 2000 Dodge Stratus?

1 Answer

Terry Hair

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Dodge Master 4,134 Answers
  • Posted on Oct 02, 2017
Terry Hair
Dodge Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Sep 15, 2011
Answers
4134
Questions
2
Helped
1092018
Points
16804

MAF sensors are located on the air inlet trunk to the throttle body, after the air filter. Located the air filter box and follow the air tube toward the engine. You will find a module in-line with an electrical connector attached. This will be the MAF.

5 Related Answers

Anonymous

  • 566 Answers
  • Posted on Dec 20, 2008

SOURCE: Where is the mass air flow sensor located on a jaguar x-type

hi from the uk the location of mass air flow sensor on x type jag is as follows==it is on the r/h/side of the air filter cover with jaguar embossed on top? this sensor is just prior to the intake hose that connects to the motorised throttle body from filter connections underneath it to unplug and meter is held by two screws ?if memory serves ? may i suggest you remove the large hose and use a little wd40 or similar to clean /lubricate the throttle butterfly in throttle body throat at this point so as to prevent future sticking upsetting of idling ? hope this helps ?

Ad

Anonymous

  • 5081 Answers
  • Posted on Aug 03, 2009

SOURCE: Mass Air Flow problem

The M.A.S. is in the top of the metal tube between the air filter box and the intake manifold. It will have a wire connected to it and it is held in by 2 screws. This is an easy replacement and should take no more than 5 to 10 minutes, assuming you are taking your time.

Anonymous

  • 15935 Answers
  • Posted on Sep 04, 2009

SOURCE: location of mass air flow sensor

The sensor is mounted on the throttle body between the air cleaner assembly and the air cleaner outlet tube.

4641370.jpg
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Larry Chandler

  • 1149 Answers
  • Posted on Feb 07, 2010

SOURCE: Location of mass air flow sensor, 2000 Grand Prix GTP

Hi:
The mass air flow sensor is a round sensor that is mounted in the air intake, between the air cleaner box and the engine throttle body.

Richard Smith

  • 64 Answers
  • Posted on Apr 21, 2010

SOURCE: Where is the Mass Air Flow Sensor?

It is inline with the air intake .They are typically held in the tubing with hose clamps and a 2 or 3 wire connection. Make sure you check for direction of air flow.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the master air flow sensor for 2005 dodge stratus

It's called a mass air flow sensor, and it can only be between the air filter and the throttle body.
0helpful
1answer

Where is the mass air flow sensor location on 2000 Dodge Stratus? Anyone have a detailed picture?

https://www.bing.com/videos/search?q=what+Where+is+the+mass+air+flow+sensor+location+on+2000+Dodge+Stratus%3f&view=detail&mid=A9D4A214797FB5063B1DA9D4A214797FB5063B1D&FORM=VIRE Follow this link
1helpful
1answer

02 stratus, 3.0, Code PO171, Lean on # 1 bank? Could this be something "other" than injectors?


It would help if you could get the car scanned with vag-com, it will show the full fault code.

P0171/ Fuel Trim; Bank 1: System Too Lean
Possible Causes

* Mass Air Flow Sensor defective

Possible Solutions

* Check Mass Air Flow Sensor
* Check Fuel Pressure Regulation
* Check Fuel Pump
* Check Injectors
* Check Intake System for Leaks
* Check Exhaust System for Leaks
* Check Secondary Air System for Leaks
* Check Vacuum Pipes for Leaks
4helpful
1answer

Need to find location of mass air flow meter 2000 dodge caravan 3.3 v6

Chrysler does not use a (MAF) Mass Air Flow sensor. They use a MAP ( Manifold Absolute Pressure) sensor.

It is located on the intake manifold near where the throttle body bolts to it.
airjer995_18.jpg

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

3helpful
2answers

Location of mass air flow sensor, 2000 Grand Prix GTP

Hi:
The mass air flow sensor is a round sensor that is mounted in the air intake, between the air cleaner box and the engine throttle body.
1helpful
1answer

Mass air flow sensor on a 1995 dodge stratus is located where?

Try to unplug maf sensor and try to start and run. ECM will go to default values. I vehicle starts and runs with sensor discoed then that is the problem. Make sure all connections for air induction between maf an intake are tight and there are no leaks. Air leaks after maf sensor will cause runability issues.
5helpful
3answers

MAF Sensor 2004 Dodge Stratus

If your car has a MAF (Mass Air Flow) sensor, it would be located in the air delivery tube that runs from the air filter box to the throttle plate assembly on the intake manifold. It will have a wiring connector going to it, also. The MAF does exactly what it is called: It "senses" the volume, or "mass" of the air-flow; thusly it needs to be in the intake air tube. If you do NOT have such a device in the air-tube, you have a MAP sensor, (Manifold Absolute Pressure); this is another way of measuring the same air volume, albeit older technology. You will commonly find this device on the firewall, with a vacuum line running to the intake manifold.

I hope that this sheds some light on your question.

Thanks for choosing FixYa for advice!
0helpful
1answer

Map sensor bad and can't find one

A manifold absolute pressure sensor (MAP) is one of the sensors used in an internal combustion engine's electronic control system. Engines that use a MAP sensor are typically fuel injected. The manifold absolute pressure sensor provides instantaneous manifold pressure information to the engine's electronic control unit (ECU). This is necessary to calculate air density and determine the engine's air mass flow rate, which in turn is used to calculate the appropriate fuel flow. (See stoichiometry.)
An engine control system that uses manifold absolute pressure to calculate air mass uses the speed-density method. Engine speed (RPM) and air temperature are also necessary to complete the speed-density calculation. Not all fuel-injected engines use a MAP sensor to infer mass air flow; some use a MAF (mass air flow) sensor. Several makes use the MAP sensor in OBD II applications to test the EGR valve for functionality. Most notably General Motors uses this approach.

Find one HERE at eBay and have it in 2 days or so...
http://cgi.ebay.com/New-New-Map-Sensor-2003-04-Chrysler-Sebring-Stratus_W0QQitemZ120354312704QQcmdZViewItemQQptZMotors_Car_Truck_Parts_Accessories?_trksid=p3286.m20.l1116
Not finding what you are looking for?

1,060 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...