If the crank sensor you're replacing looks like this this would be located by the harmonic balancer (crankshaft pulley).
SOURCE: crankshaft position sensor
Here you go:
Fig. 3: Crankshaft position sensor (1) is located next to the oil filter (2) on the 2.4L engine
SOURCE: mechanics at my local garage cannot locate crankshaft sensor
the crankshaft sensor will be located under the starter motor and the air intake manifold will have to be removed to gain access to this
SOURCE: location of crankshaft sensor
Hello mitchoreb: My name is Roger and I will be glad to help with your answer. You will need to raise the vevicle in order to see the sensor. Make sure to use safety stands when ubder the vehicle when raised up.Look in the area behind the oil filter.Just in front of the knock sensor.This will be just above the oil pan rail.The knock sensor is a round sensor with a round plug.The crank sensor should hove a oblong plug. You should have a picture along with this reply. Should you need any further help please just ask. Please rate the answer you received as this way we know you recived helpful information. Thank You for using FixYa.Roger
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: crankshaft sensor location on 2001 oldsmobile
. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wIre CONNECTOR plug to the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery.
290 views
Usually answered in minutes!
×