Make sure the pigtail isn't melted also, very common for the pigtail plastic to melt on the inside and short out. When replacing the module or resistor, always replace the pigtail that goes into it. Common for it to melt.
SOURCE: battery removal on a 2004 GMC Envoy
The battery is on the right side behind the fuse box. You need a metric set to undo the 3 screws. Theres one that attaches to the body, one to the bar that goes along the top, and theres one on the left side below the vacuum hose and air induction. After you've taken out those three, you should lift the whole thing out(battery and shroud) together. It's hard to take the shroud off before you lift the battery out. After that, you have to pry the shoud off the battery. The two terminals in the back make it hard. Then just go to any auto parts store and they'll give you a new one.
SOURCE: Speedometer on 2004 GMC Envoy not working. It
There is a recall on the panel Cluster... call your dealer and have it checked out.. mention the recall... www.lemonauto.com
SOURCE: heater fan only works on the high position?
There is a plug up under the glove box that loosens and you need to snug it up.
SOURCE: 2004 GMC Envoy rear hatch complete door wont
door lock actuator solenoid ( inside of door) needs to be replaced
SOURCE: i have a climate control problem on 2004 gmc
The likely problem is the blower motor resistor pack is defective. It is located behind an access panel below the glovebox. Go to www.trailvoy.com and do a search on "blower motor resistor replacement"
90 views
Usually answered in minutes!
×