Replaced bcm in 2006 chevy hhr. does the unit have to be reprogramed
Has to be programmed ,yes .
Body Control Module (BCM) Replacement
If the BCM is replaced, the following procedures must be performed in the subsequent order:
• BCM Reprogramming--Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems for replacement, setup, and programming.
• Theft Learn--Refer to Programming Theft Deterrent System Components in Theft Deterrent.
A new body control module (BCM) must be programmed with the proper regular production option (RPO) configurations. The BCM stores the information regarding the vehicle options and if the BCM is not properly configured with the correct RPO codes, the BCM will not control all of the features properly. The Tech 2 software will automatically prompt you with the RPO available for the vehicle. Ensure that the following conditions exist in order to prepare for BCM programming:
• The battery is fully charged.
• The ignition switch is in the ON position.
• The data link connector (DLC) is accessible.
• All disconnected modules and devices are reconnected before programming.
To setup a new BCM, access the Vehicle Control Systems in Computer/Integrating Systems menu on the scan tool to program the BCM. Select Module Replacement/Setup and follow the instructions on the scan tool.
If the BCM fails to accept the program, perform the following steps:
• Inspect all BCM connections.
• Verify that the scan tool has the latest software version.
SOURCE: 2006 chevy hhr transmission fluid and filter change
usually a pan under the trans. anywhere from 10 to 22 bolts. filter inside. some vehicles have an oil style filter on the externally, but i don't think that this is one.
SOURCE: air filter on chevy hhr
The air filter is in the large plastic cover that covers the engine.
1. Remove MAP sensor connector ( slightly hidden under the front center edge of the housing. Wiggle slightly and pull straight out).
2, Loosen (but don't remove) the large hose clamps on the passenger side and center of the housing, It's a tight fit for the hands on the passenger side and the head of the clamp is facing away from you. The front center hose is stiff, but pliable, so take your time.
3. The
air filter housing was designed as a snap in with rubber grommets. A
firm steady pull with the front passenger side will show you how much
effort it will take to pull it free. Do each of the remaining two
separately. The housing will be free to remove from the vehicle.
4. On a clear area, turn the housing over and loosen the seven torx type screws (they will not come completely off, so as not to lose them). Pull the cover off. Remove the old filter and replace with your new one. Align the cover and snug the screws back in.
5. Reassembly requires lining up those
rubber grommets to the mounting studs.... take your time.... all that
is needed is a firm downward push to seat them.
6. Reattach the large hose clamps and remember to plug in the MAP sensor (you'll get an "check engine" light if you forget.
Hope this helps.
SOURCE: where do you put the power steering fluid in a chevy hhr 2006 model
the power steering fluid resevoir is located on the passenger side of the engine compartment near the fire wall. mostimes in order to fill it you have to remove the altenator to remove the fill cap to add the fluid.
SOURCE: how do you replace a blower motor on an 06 hhr
you need to cut out the bottom of the box where the motor sits and get an blower motor attachment kit from local gm dealer
1,144 views
Usually answered in minutes!
×