2004 hyundai accent
SOURCE: Replace oil pan on my Hyundai accent 2004
You can try to re torque the bolts before you drop the pan and re place the gaskit if that is where your leak is coming from. Good luck and hope you don't have to drop the oil pan.
SOURCE: 2004 passat rear door lock
fold down the rear seats, pull the the frabic cover besid the seat out of the way, and pull a samall bit of the door seal out of the way then u sould be albe to to see the child lock button and try to turn it to the ope position with a screw driver with the end bent at a 90 dregee angle (or something else like that) with the child lock off u should have no prob
SOURCE: changing timing belt on 2004 hyundai accent
Sign up for an account on hmaservice.com. Once you do so, log in and click on "Shop". You can then enter your year/make/model and you will find the info under, engine mech. system>timing system>timing belt>repair procedures. Very detailed, and best of all, FREE.
SOURCE: Hyundai Accent 1.4L GLS 2000 Central Locking not working
FOR Central locking not working
on 2000 Hyundai accent?Click the link below :-----
http://schematicsdiagram.blogspot.in/2012/03/this-is-how-system-operates.html This will help. Thanks.
Testimonial: "Thanks Raj for the swift reply, Mark"
SOURCE: My 2004 Hyundai accent's alarm goes off randomly some time after the car is locked
Can you clarify if its an aftermarket alarm or factory? If its a factory, your horn goes off. If its an aftermarket, a 6 tone siren goes off. I am going to assume its an aftermarket, so check the number of flashes of your LED upon disarming. The alarm registers the trigger and identifies it for later troubleshooting until you reset it by turning on the ignition. Most alarms use 2 flashes for the impact sensor, 3 flashes for door trigger, 1 flash for ignition trigger. If you get 2 flashes that means your impact sensor is way too sensitive and must be turned down a little bit. If you get 3 flashes that means there is a faulty door pinswitch which is causing the alarm to trigger. If its an a factory alarm then the problem might be with the faulty door pinswitch.
http://schematicsdiagram.blogspot.in/2012/03/this-is-how-system-operates.html
This will help.
Thanks.
34 views
Usually answered in minutes!
×