To Adjust :
1- Unclip parking brake boot.
2- Detach the center console upper section.
3- Disconnect cigar lighter electrical connector.
4- Remove te center console upper section , disconnect the transmission mode and traction control electrical connectors
5- Move the selector lever to position "R"
6- Loosen the selector cable lock nut
7- Detach the selector cable.
8- Raise and support the car.
9- Move the Rotary position switch to the "R" position , so that it matches the lever.
10- Lower the car.
11- Connect the selector cable (Do not tighten selector lever lock nut)
12- Move selector lever to "D" , hold the selector lever applying light pressure and fingure tighten the rear lock nut , then fingure tighten the front lock nut
13- Now move the lever to different gear positions , ( when "D" is selected , make sure it sits as close as possible to the "D" and "4" position in each corner.
14- Tighten selector lever lock nut.
15- Install center console upper section. (connect the transmission mode and traction control electrical connectors)
16- Connect the cigar lighter connector
17- Install the center console upper section.
18- Clip together the parking brake boot.
And you are done , I know it looks hard but it is not , read through my instructions and understand it and all will be easy to do.
Good luck , hope it helped :)
2,249 views
Usually answered in minutes!
×