SOURCE: suddenly without brakes or power steering
check belt and check p/s fluid if ok pump is probably bad with truck running you should be abel to see the fluid flowing threw th reservior when running
SOURCE: i have a 2003 escalade ext. when i turn on my
THIS PROBLEM MAY BE A DEFECTIVE TURN SIGNAL SWITCH OR A DEFECTIVE BRAKE LIGHT GROUND, THE BRAKE LIGHTS ARE GROUNDED NEAR THE SOCKETS, YOU WILL NEED TO PULL THE TAIL LIGHT ASSMEBLIES OUT TO CHECK THESE GROUNDS TO THE SHEET METAL.
SOURCE: bleeding brakes 2000 suburban wsith ab
Why were the brake lines replaced?
Sounds like the mastercylinder may have run dry. You have to bench bleed the master and then DO NOT allow fluid to run low, while bleeding brakes...
if master cylinder runs low on fluid and air gets in, almost impossible to bleed with out releasing the lines and bleed master it self.
SOURCE: i just changed the brakes all the way around a
Check the ABS hub reluctor ring to make sure it was not damaged in any way when you put everything back together. Also check all the wires to make sure none are crimped or disconnected. Lastly check the brake master cylunder for fluid level. Sometimes after retracting the pistons forcing more fluid into the master cylinder will cause this meesage. If the fluid level is to high simply remove some.
832 views
Usually answered in minutes!
×