I have a 2014 suzuki grand vitara and stereo / radio will not work . When ignition on screen comes up white with a thin black cross / and touch here . Yet when i touch ( touch here ) it moves to another part of screen .. Any ideas / suggestions please .. cheers

Anand Kumar

• 2035 Answers
• Posted on Jul 15, 2008

SOURCE: suzuki grand vitara 2.0 TDI

This could the problem with onboard computer failure .......

try that after visual check under hood confirms no obvious failures like missing drive belt or disconnected electric wires...

Please mention make code and year of the peugeot engine in the car.....

Good luck....

SOURCE: where is the starter for a 2000 suzuki grand vitara located

starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch

SOURCE: can't find the fuse box under the driver's side dash on my 2000 suzuki grand vitara. my radio/clock not working and dome light does not come on when the driver's side door is opened.

Its below the Dashboard, on the left side of your knee. You have to use a torch & locate it from under the Dashboard, Its roughly near to the Clutch Pedal.
Here, it looks like this: (The Black one is the Fuse box)

SOURCE: central locking fob

Programming
When
Remote control buttons operated repeatedly while vehicle out of range and system becomes inoperative. System malfunction.
How
Ensure ignition switched OFF and all doors closed. Proceed as follows: Within 10 seconds, open driver's door and switch ignition ON. Within 10 seconds of switching ignition ON, switch ignition OFF. Within 20 seconds of switching ignition OFF, press and release driver's door contact switch 3 times. Within 10 seconds of releasing driver's door contact switch, switch ignition ON then OFF. Within 20 seconds of switching ignition OFF, press and hold both remote control buttons in turn for at least 5 seconds. The driver's door should lock and unlock once. Within 5 seconds of driver's door locking/unlocking, press remote control lock button Fig. 1 [1] or unlock button [2]. Programming procedure complete. Confirm programming has been successful by locking and unlocking vehicle.
NOTE: A maximum of 2 remote controls can be programmed.

ZJ Limited

• 17989 Answers
• Posted on May 15, 2010

SOURCE: How to change the fuel filter on a suzuki grand Vitara

Fuel FIlter - Removal

1. Relieve fuel system pressure.
2. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.
   

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.