Don't try it yourself. Aiming headlights takes special measuring equipment. Take it to a shop that advertises headlight aiming. That way you won't get a ticket for improper headlight aim.
SOURCE: change logo on screen of 2011 ford edge
May want to read the owners manual & sit down
at the dealer for some guidance
SOURCE: Low beam headlight adjustment on 2011 Chrysler 200
How to Adjust Car Headlights Level your car. Start by removing any excess weight from the trunk of the car. Also, ensure that the tire pressure in all tires is at the manufacturer's recommended levels. If possible, have somebody sit in the driver's seat, and that the gas tank is half-full. As well as this, check that your headlight aim adjustment wheel (if fitted) is at the zero position. Position your car. On level ground, park 10 to 15 feet (3.0 to 4.6 m) from a dark wall or garage door, with the front of the car aimed at the wall. A paved parking lot or level driveway is best Turn the headlights on. Do not use your high beams or fog lights. Mark the horizontal and vertical center lines of the headlight beams with masking tape to make two T's on the wall or garage door.Make sure the lights are level. Place a carpenter's level between the two marked center lines to see if they are even. If they are not even, use a tape measure to measure how far up the wall the lower mark is and lower the other center line marker to the same height. These center lines should be no higher than 3.5 feet (1.1 m) from the ground.Back your car exactly 25 feet (7.6 m) from the wall or garage door. Don't estimate the distance! Use a tape measure to make sure you are the proper distance away from the wall. Turn off the headlights. Remove the trim ring from around the headlights and locate the adjusting screws. These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights. The horizontal adjuster and the vertical adjuster should be marked.
1,547 views
Usually answered in minutes!
×