Question about Hyundai Cars & Trucks

1 Answer

Running lights arent working drivers side 2007 hyundai santa fe with factory towing harness tailights both won't work when towing trailer

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Hyundai Master
  • 53,755 Answers

Check the wiring in the trailer plug as it may not be pin for pin in the car plug

Posted on Aug 01, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
kakee

Michael Galve

  • 1269 Answers

SOURCE: HOW TO YOU GET AT PRESSURE SENSOR ON COMMON RAIL HYUNDAI SANTA FE 2007 CDX

This is what it looks like

47cf2f5.jpg

Posted on Oct 28, 2008

silver top

  • 566 Answers

SOURCE: 2007 Hyundai Santa Fe - Replacing fog light

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?

Posted on Oct 28, 2008

tracer_steve

Steven Mitchell

  • 68 Answers

SOURCE: hyundai santa fe 03 running problems

If your Santa Fe has a V6 engine 2.7L , it sounds like you have an ignition break down happening. You will need to renew all the ignition wires and check the two coils also for arcing .

Posted on Apr 01, 2009

goalie39

Ed

  • 476 Answers

SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe

If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.

Hope this is of some help.
Ed

Posted on Apr 21, 2009

emissionwiz

Marvin

  • 85206 Answers

SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE

This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.

Posted on May 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What fuse to replace on 2008 Hyundai Santa Fe


welll...look at your owner's manual and you will find the answer!

Jul 14, 2014 | 2007 Hyundai Santa Fe Limited

1 Answer

Can 2003 be equiped with towing trailer package


you can add a receiver hitch made for that vehicle. for light towing you should be fine. it won't handle a car trailer or Large boat.

Apr 26, 2014 | 2003 Hyundai Santa Fe

2 Answers

I've replaced the bulbs on the rear tail light assembly and the driver's side light still won't work when the lights are on at night.... where is the particular fuse for this problem in the fuse box?


If the drivers side will not light up and pass/side will light up, they run on the same fuse. I would start with pulling the light bulbs out and check to see it there is power coming back at all, with a volt meter, if there is may have to clean off the contact points where the bulb fits in, if not may have to trace the wires back to front to see if something got cut, if you have trailer lights for towing look at the wires there to see if somthing has rubbed the plastic off the wires and grounding out. dose the turn signal light work on that side? and the reveres light work on that side?

Mar 09, 2011 | 2002 Hyundai Santa Fe

1 Answer

I plan on towing a trailer 2500 ish lbs. Fully loaded behind my 2002 Hyundai Sante Fe with the V6 engine. My ex says I need to get a transmission cooler installed. Do I?


Well, you don't have to have a transmission cooler installed if you go a short distance.

But, it would help if there is none from the factory and you go a long distance on hilly terrain.

My 1980 Suburban had a cooler built in for towing things.

Hope this helps you.

Jun 22, 2010 | 2002 Hyundai Santa Fe

1 Answer

While pulling a trailer the trailer lights wire got pinched and shorted. We fixed the wire but the power from the harness seems dead. We can't find the fuse. 2009 Hyundai Santa Fe Any Ideas?


I am not completely familiar with that make and model but I believe you will find the fuse you are looking for under the hood. There should be an accessible fuse/relay box located normally on the same side of the vehicle as the battery. If you have an owners manual for the vehicle that should have a layout of the box. If not, then a voltmeter can be used to find the blown fuse.

Apr 27, 2010 | 2001 Hyundai Santa Fe

1 Answer

2003 Hyundai Santa Fe. Driving about 10 minutes-stop at redlight and all dashboard lights come on and brakes feel locked. Have to restart ignition and then it's fine. Happened about a month ago as well....


Wiring harness runs along the left side of this vehicle between the engine compartment & the instrument panel junction box (left side under dash). damage may have occurred to this harness and no one found/noticed it.

Oct 08, 2009 | 2003 Hyundai Santa Fe

1 Answer

Trailer running lamps will not work


Your running lights/marker lights and tail lights are on the same circuit. I all thetruck lights work, the problem is in the plug or plug harness.

Jul 01, 2009 | 2007 Chevrolet Silverado 2500HD

1 Answer

Where are the mounting points ona santa fe for a towbar?


well there are two ways to solve this. you can either A let uhaul install one. not that pricey and pretty good or B buy one and use the instruction

here is a site for a front tow bar
http://www.google.com/products?hl=en&q=tow+bar+for+a+hyundia+santa+fe&um=1&ie=UTF-8&sa=X&oi=product_result_group&resnum=4&ct=title


here is one for a trailer hitch
http://www.google.com/products?q=trailer+hitch+for+a+hyundia+santa+fe&btnG=Search+Products&hl=en&show=dd




good luck

Jason

Jan 20, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Tow my vehicle behind


If its an auto trans ,a trailer! A standard, you will need to buy the propper harness. This would enclude wiring the lights in too! Frankster016

Oct 23, 2008 | 2002 Hyundai Santa Fe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...