2006 Mini Cooper air blend door actuator Questions

Marvin

• 85242 Answers
• Posted on Sep 23, 2008

SOURCE: Blend door not working.

The bleed door controls air temp not where it comes out, dash, floor, defroster, this is most likely a mode control switch problem, that switch is on the ac control head.

SOURCE: how do I reset my

you can not reset it. all you have to do is go to the dealer and get a new sensor. once the sensor touches the disk it opens up the circuit, thus you have your brake pad warnning.

SOURCE: how do you replace the coolant on a 2006 mini

this is how i replace the coolant on minis. remove the lower splash shield and disconnect the lower radiator hose right off the radiator. when it stops draining, resecure the hose and clamp. next , ur going to have to refill and bleed the cooling system.i do this through the coolant resevroir. this is important, or else ur vehicle is going to overheat and boil over no matter if the system is full or not. there are 2 coolant bleeder valves. open both valves a little and fill the coolant system with the correct coolant. fill the coolant. fill the coolant till it begins to come out of the 2 valves . when coolant begins to come out through the valves slowly and steady with no air pockets , go ahead and close up both valves and run vehicle to normal operateing temps, make sure vehicle isnt overheating and u should be fine. u may have to repeat the procedure over again. once u do it once u remember how next time. ( the two bleeder valves are sort of hard to explain in words where they are, they arent hard to access ) u can turn them with a flathead screwdriver) they are usually black and plastic.

honeymokey

• 3113 Answers
• Posted on Apr 15, 2009

SOURCE: air blend door

Replace the broken actuator.

SOURCE: my car key dead on mini cooper 2006. how I change

Should be able to "Pop" case open, case is tightly sealed with o-ring