SOURCE: water pump replacement in a 2002 Mazda MPV
The reason is the water pump is driven off the timing belt, extra parts and allot more labor. No the eng does not have to be removed, labor time around 4 hours, parts about, about $125 US for parts, if it is a dealer add $75 US
SOURCE: program remote control for mazda mpv 2002
Courtesy of: forums.mazdaworld.org
Try this, it works on several 2002 models:
Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the drivers door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT
- use ON position NOT ACC position). Do this 3 times within 10 seconds.
Leave key in the ignition.
Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a
final time with a series of door locks and unlocks. You're done
SOURCE: replace transmission control module?
You should really have a qualified tech. replace this control unit. It is located in the foot well in passenger side. There is a false floor held in by 10mm nuts that the unit attaches to. You will more than likely need a S.D.S. machine to download the software out of the old unit and into the new unit. Next you will have to version code the new unit and set the parameters for your shift points. I have never replaced one and tried to start and drive the vehicle w/o the S.D.S.. I can't be sure it would be drivable but there is only one way to find out. Either way you will have to take to appropriate repair facility and won't have the same warranty replacing it yourself. What ever you do do not remove the electrical connector with the key on, I also hope that the vehicle was properly diagnosed. Hopefully I have been helpful. Good luck
SOURCE: how do I replace alternator in mazda mpv 2000?
Typically an alternator is an easy fix. It requires removal of the belt from the engine running it, and a few bolts that attach it to the engine.
Because of the engineering with the 2000 mpv, it is a very difficult fix, and one that requires removal of the transaxle and exhaust manifold, as well as removal of the lower engine mounts. It will take a qualified Mazda mechanic 3.5 hours to do the fix - you can (at least) triple that amount of time as a DIY project (assuming you have the right tools).
SOURCE: location of 2006 mazda 3 airbag module.
look under the cup holders in the center console - should be simple to take out once you lift the emergency brake handle up.
181 views
Usually answered in minutes!
×