Finding the knock sensor on a 2002 Toyota tocoma 3.4 engine

francisco navarro

• 241 Answers
• Posted on May 15, 2008

SOURCE: knock sensor

The knock sensor threads into the side of the cylinder block.

1. Disconnect electrical connector from knock sensor.
2. Use a crow foot socket to remove the knock sensors.

1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing improper spark control.
2. Attach electrical connector to knock sensor

SOURCE: 2002 jeep liberty 3.7 engine where is knock sensor

get the pcm computer checked first for errors.
The 2 knock sensors are bolted into the cylinder block under the intake manifold. The sensors are used only with the 3.7L engine.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280221909

what are your sysptoms of no start?

SOURCE: Location of knock sensor on 1994 toyota 22vre engine

The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.

SOURCE: Need to locate knock sensor on 1999 camry V6. Where is located.

i have toyota windom 4vz-fe i need locate knock sensor

SOURCE: i can't find knock sensor location bunk 2 toyota sienna 2001

It's under the intake manifold...oh joy

Testimonial: "you are a nice guy. i'm so gratefull you have this in the networth. thanks."