SOURCE: 1984 s10 2.8 manual trans. flywheel causes engine to vibrate
no should be same engine. check your engine mounts and tranny mount. how bad a vibration? sometimes after installing engine the trans gets shifted around and if mount was worn it will allow it to hit crossmeber and vibrate.
SOURCE: chevy 1996 s10 pedal position code?
Another name for it is throttle position sensor. It is usually on the side of the throttle body, usually black in color, has a 2 wire connection, attached with 2 screws. Needs replacing.
SOURCE: Van keeps running after turning off ignition and removing key
need to check the engine timing and to make sure you have the right octune of fuel in your car.
SOURCE: how do i remove the starter motor from a 1994 S10
in those is very easy, first do not forget to remove one of the battery cables, jack the truck and locate the starter ,under the passenger side, disconnect the +battery cable at the starter , a big one , red, and another small wire wish is the ignition wire, remove the two long bolts that attach the starter..one easy way is having the new starter so you can see how it looks and where the bolts go...hope this was very helpful..
SOURCE: 01 Suburban engine, 8.1 liter, abruptly turns off
Its the crank sensor. There was a recall a few years back for 2001 8.1 liter engines crank sensor. Engine would shut off perodically and sometimes would not restart untill cool. Plus it just happened to mine. about a 350 dollar dealer fix.
189 views
Usually answered in minutes!
×