At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
After an oil change, or when "CHANGE OIL"
appears on the Trip Monitor, with the ignition on and engine off, press the
"ENG MET" button (located on trip monitor) once. Press the "ENG MET" button
again within 5 seconds. Within 5 seconds, press and hold the "RANGE" button
(1990-1994) or "GAUGES" button (1995). The light will flash. When it stops
flashing and goes out, the system is reset.
Hope this helps and just keep in mind that your feedback is important
and I'll appreciate your time and consideration if you leave some
testimonial comment about this answer. Thank you for using FixYa.
Hello,
There is no reset button for your Corvette. You may have an issue with the security system. Check if the Security light is on or flashing while trying to start the car.
I hope this helps.
assuming you mean replacing the bulb? about $2.00 a bulb
the bulb is push and twist, open the hood and remove the plastic cover then remove the bulb by pushing it down and twist it a little till it pops out. I see only one light , I think my 1994 vette has two photo
hope this helps
Eric
Unless there is something wrong with you buttons the procedure is as follows: 1. Turn ignition key to ON (not start) 2. Press ENG MET button on trip monitor & release, then press it again within 5 seconds. 3. Within 5 seconds again press and hold GAUGES button until Change Oil lamp flashes. 4. Continue Holding Gauges button until lamp stops flashing & goes out. 5. You should be done, start & shut off car. If it didn't work turn off car and start from top.
Some buttons are very sensitive so try and be deliberate & steady when holding.
1. Turn the key to “Run,” but don’t start
2. Press “ENG MET” on the Trip
the engine.
Monitor. Then, within five seconds,
press it again.
3. Within five seconds, press and hold
“GAUGES” on the Trip Monitor. The
“CHANGE OIL” light should flash.
4. Hold the “GAUGES” button until the
“CHANGE OIL” light stops flashing
and goes out. This should take about
ten seconds.
When the light goes out, the monitoirs
reset. If the monitor doesn’tr eset, turn the
ignition off, then try again.
×