Gear shift wont stay in gear.
SOURCE: truck shakes when taking off in first gear
This happens from overheating the clutch, and it is caused by a burnt/overheated flywheel and pressure plate, it may be your driving habits, do you slip the clutch allot or have you been stuck where you might have overheated the clutch trying to free the truck from mud or snow?
SOURCE: Transmission shifting proublem M5R1 1997 FORD RANGER
You might have to try to adjust the freedom of clutch pedal,
The noise during shifting can be adressed to exessive wear clutch parts or again it might be a sign that indicates the not complete enabling the calutch
To find out what is causing the noise, set the parking brake, place the vehicle in neutral and start the engine.
If you hear growling or grinding noises when the clutch is engaged, the cause is the transmission input shaft bearing.
A squealing sound that occurs when the clutch pedal is depressed and held is usually caused by a bad pilot bearing or bushing.
A chirping noise that intensifies when the pedal is slowly depressed would indicate a bad release bearing.
If you hear chirping while idling in neutral and the noise goes away when the pedal is slowly depressed, the fork/pivot ball contact point is making the noise
Hope that helps.
The clutch adjustment procedure you can find at
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528018f021
More about clutches
http://www.aa1car.com/library/2002/ic100237.htm
Good Luck
SOURCE: 1995 crown vic gear problems/gear shift wont lock
most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.
SOURCE: How do you remove the gear shift lever on a 93 ford ranger?
many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck
182 views
Usually answered in minutes!
×