Chevy traverse side mirrors not working no manual for the vehicle.

Compare, they are listed as different.

Chevrolet Traverse (2009-2017) fuses and relays

https://fuse-box.info > chevrolet > chevrolet-traverse-20...

Fuse box location. It is located underneath the instrument panel, on the passenger side, under the cover.

1st check out the fuse box for fuses not good...does the right one work....if it does your fuses should not be a problem.

buy a couple of canisters of freon and a hookup start vehicle and turn on a/cv hook up to low side and start charging watch for sweating on low side line and your done How to Add Refrigerant to 2009 2017 Chevrolet Traverse 2013 Chevrolet... Chevy Traverse AC recharge 2017

ankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or use ramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! You must unbolt old sensor (10mm bolt) and remove it, prior to disconnecting wire, as it is nearly impossible to disconnect wire first. It is held on by a small red lock clip.Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.

I think you should go for manual first after that it would be easy for you to solve your problem. I had visited this site past 2 months before for my vehicle and find it quite helpful may be you will also get something useful here Best Manuals

How do you access the fuse box on a 2010 traverse?

Fuse under the right passenger dash. Fifth up on the right (blue 15 amp). It is called BCK/UP/STOP. All the same symptoms short in wiring harness for the trailer package caused the windows not to function, the right rear turn signal had no power, and the key was stuck in the ignition.

I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.

I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.