SOURCE: wheel bearing ford contour
this comes a a hub assembly
you need to remove the brakes and brake rotor
the center nut holding in your CV shaft
in the hub you will find holes that you can put your socket threw to remove the mounting bolts.
SOURCE: front wheel bearing/tools
big spanners, or shifter, deep sockets, hammer, drift, screwdriver, and clean cloth. don't forget the bandaids,
SOURCE: packing front wheel bearings
what I do is put a glob of grease in the palm of my hand and push bearing down in to grease untill you see the grease come out of the bearing or you can go to your local parts store and get a bearing grease packer. also wipe spindal with a genorus glob and put grease in between bearing in rotor. To get to the bearings all you need to do is remove tire, center cap (outter grease seal) the silver cap in the center. the cotter pin, Nut, washer outter bearing then the rotor will slip off inner bearing is in rotor still being held in by inner grease seal take seal off replace with new one pack your bearings and reverse removal procedure when retightening nut do not make tight just snug the go another turn if you go to tight you will burn your bearings real fast.
SOURCE: Want to replace fron in 93 ford probe
1993 is a split year, if you have charging ports are a little bigger than the size of a tire valve stem then u have R12, if they are big then you have R134, most all Ford in 93 use R12. In the picture are adapters for a retrofit to R134, these screw on an R12 port, note the large cap R134 cap on the end of the adapter.
SOURCE: i cant seem to get the timing right on my 93 ford
Mark the direction of rotation on the timing belt in case you need to re-install the original belt
Cam and crankshaft sprocket alignment positions for the 2.0L engine
Rotate the crankshaft until the timing marks (arrows) on the camshaft sprockets align with each other
Please don't forget to rate
84 views
Usually answered in minutes!
×