Where is my fuel filter located on my 2006 GMC Envoy????

SOURCE: location of fuel filter 2006 suzuki aerio

In the fuel tank, accessed by removimg the fuel pump.

SOURCE: Fuse Box Location 2006 GMC Envoy

Under the rear seat, drivers side.
Black box you will need to remove the cover.
Lone99star
Please rate this solution.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/jason_77a19afa8d604dee

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: gas gauge on 2006 gmc envoy says empty after fill up

this is a giant comon problem right now with gm vechiles it is in the fuel sending unit the unit needs to be replaced ( about 400$) and the gas tank needs to be dropped out to get to it for many more people with the same proble go to topix.com there is about 96 of us with the same problem

SOURCE: where is the fuel filter on '05 gmc envoy i-6

the fuel filter on a 2005 envoy is under the truck on the drivers side in the middle you have to take off the protector plate to see it you vant miss it
good luck

Greg Bernett

• 2993 Answers
• Posted on Oct 12, 2009

SOURCE: Location of ignition switch on 2006 gmc envoy

PATH: Chassis Electrical > Instruments & Switches > Ignition Switch > Removal & Installation Removal & Installation

1. Disconnect the negative battery cable.
   
2. Disable the airbag system, as outlined in the Chassis Electrical Section.
   
3. Remove the hush and knee bolster.
   
4. Remove the steering column trim covers.
   
5. With the key installed, turn the key to the RUN position.
   
6. Install a hex wrench into the hole on top of the lock cylinder housing. Push down on the hex wrench to release the tab on the lock cylinder inside the lock cylinder housing.
   

1. Slide the lock cylinder out of the lock cylinder housing.
   
2. Disconnect the passlock and key buzzer from the lock cylinder housing.
   
3. Insert into the lock cylinder housing
   

1. Pull the ignition switch out of the lock cylinder housing.
   
2. Disconnect the connector from the ignition switch.
   

1. Verify the alignment of the gear in the ignition switch. If gear is not in position shown, turn gear in ignition switch until you reach the correct position.
   
2. Use a screwdriver to rotate the lock cylinder housing gear counterclockwise until it hits a stop. In order to reach a stop while rotating the lock cylinder housing gear you MUST push and hold in the solenoid on the electric park lock.
   
3. Connect the connector to the ignition switch.
   
4. Insert the ignition switch into the lock cylinder housing. The tabs on the ignition switch MUST be seated inside the lock cylinder housing for proper installation.
   
5. Use a screwdriver to rotate the lock cylinder housing gear clockwise to the start position—allowing it to spring return into the RUN position.
   

1. Align the lock cylinder and install the lock cylinder into the lock cylinder housing.
   
2. Connect the passlock and key buzzer into the lock housing.
   
3. Install the steering column trim covers.
   
4. Install the hush and knee bolster.
   
5. Enable the airbag system, as outlined in the Chassis Electrical Section.
   
6. Connect the negative battery cable.