SOURCE: 2004 Chrysler Sebring- Left turn signal problems
Sounds like a short in the wiring or fuse panel. As new as it is, I would suggest a mechanic as troubleshooting wiring in newer cars is not only difficult, but also dangerous. Many a shade-tree mechanic has set off the airbags that way!
SOURCE: my 2004 crossfire's key won't turn in the ignition
I had the same problem. I had to replace the entire ignition module at my cost. It happens fast, first just sticks when turning, then a day or two later, it will lock. If you jiggle the steering wheel it will sometimes free the lock and you can turn the ignition. Just a poor design. The only way to get the ignition cylinder out is to turn the key to the on position (there are write ups on this on the internet). Most of the time that is not possible and you are stuck somewhere with no way to turn on your car. If you are able to do that do not turn the key off completely or it will probably never turn on again. Just leave it in the ACC setting until you figure out what you want to do. It is not that difficult to take the entire lock cylinder out and start the car with just the key tip that fits in the ignition slot (or a screwdriver if you have one). The only problem is that the key has a built in RFID sensor that needs to be within a few inches of the plastic piece around the key cylinder for the car to start, so even if you do that you have to find a place to stick the key to the dash right next to the ignition. Just take it to the dealer and have them fix it.
It is a very common problem and these wear out after use. A plastic actuator pushing a metal pin to unlock the key cylinder... it will be a replacement part and repair for Chrysler forever. At $525+ per repair it should be a recall, and it will happen to every crossfire owner. Mine went out at ~39,500 miles and I know it will again sometime in the car's life.
The other option is to drill out the steering wheel lock, much more difficult and extremely hard to get to under the dash. That would solve the problem forever, but most of us don't like dismantling our car's ignition and drilling into things that should not be taken apart.
Good Luck. Check out www.crossfireforum.org for other options, but everyone has had this problem.
SOURCE: I have a 2004 chrysler crossfire and the key is
Please go to: http://www.crossfireforum.org/forum/tsbs-how-articles/33074-sticky-ignition-key-fix.html
SOURCE: My 2004 Crossfire the key will not turn in the ignition and the steering wheel is lock .
Replace the ignition switch
When a headlight burns out on your Chrysler
Crossfire, you do not need to rush to the repair shop to have it
replaced. You can access the headlights in your Crossfire from within
the engine compartment, allowing you to change the headlight yourself.
The Crossfire uses an H7U headlight bulb, which you can find at auto
parts retail stores or at a Chrysler dealership.
Difficulty: Easy
138 views
Usually answered in minutes!
×