SOURCE: Location of oil filter on 2007 Toyota Solara Convertible
The 3.3 no longer has a "spin-on" filter. The filter is now a "cartridge-type", and is housed in a cricular aluminum housing under the engine.
SOURCE: How do i reset the maintenance required light
1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 145 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
reset knob.
Hold down the knob for at least 5
seconds. The odometer indicates “000000”
and the light goes off.
If the system fails to reset, the light will
continue flashing.
To reset the Maintenance Lamp turn the car key to ON (not start), set your odometer on mileage (not trip a or b), then depress and hold the button that switches from odo and trip then turn key off. Turn the key back to ON, while you are holding the button down you will notice the maintenance light blink and go out. Reset is complete and you are done.
These are available in your owners manual for the vehicle.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: Reset my engine oil low in 2007 chevy impala
it will say in your owners manual but i believe you turn your ignition key to the run position not the start. and pump the gas pedal 3 times with in 5 seconds
SOURCE: how to change the check engine light on a 2000 toyota tacoma
i had the same thing, i had it tested at auto zone and they said it was the obd2. i was told the o2 sensor was not a big deal so i reset the check engine light by holding down the trip meter button while starting her up and it has not been on since.
SOURCE: replacing front struts on a 2007 toyota tacoma
REALLY HARD PROJECT, TAKE IT TO SEARS, IT WILL ALSO NEED FRONT ALLIGNMENT
53 views
Usually answered in minutes!
×