Ac fuses 2010 Ford Escape location - Ford Cars & Trucks

SOURCE: 2010 Ford Escape hybrid. can I modify the auto lock timer?

yes it can in the message center, there should be a lenghty section on it in the owners manuel

SOURCE: where is the ac condensor on a ford escape

SECTION 412-03: Air Conditioning 2003 Escape Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 05/21/2002 Condenser Core Printable View (52 KB) Removal and Installation
NOTE: Installation of a new suction accumulator is not necessary when repairing the air conditioning system except when there is physical evidence of system contamination from a failed A/C compressor or damage to the suction accumulator.
NOTE: If an A/C condenser core leak is suspected, the A/C condenser core must be leak tested before it is removed from the vehicle. For additional information, refer toSection 412-00.

1. Recover the refrigerant. For additional information, refer toSection 412-00.

1. Remove the front bumper cover. For additional information, refer toSection 501-19.

1. CAUTION: Plug all ports to prevent contamination from dirt or moisture.
   Remove the nuts from the two condenser core air conditioning line (peanut) fittings.

1. Remove the screws and the A/C condenser core brackets.

1. NOTE: When removing the A/C condenser core, disconnect the two air conditioning line (peanut) fittings from the A/C condenser core.
   Remove the A/C condenser core.

1. To install, reverse the removal procedure.
   • Lubricate the new A/C condenser core with the correct amount of PAG Compressor Oil YN-12-C or equivalent meeting Ford specification WSH-M1C231-B. For additional information, refer toSection 412-00.
   • Lubricate the O-ring seals with PAG Compressor Oil YN-12-C or equivalent meeting Ford specification WSH-M1C231-B.

SOURCE: Need a diagram of the

This is a C/P for the 2008 Escape so I'm hoping it's the same for a 2010.
Parking Lights VIOLET/WHITE (+) DRIVERS KICK PANEL SMALLER PLUG IN D. KICK PANEL
IF THE VEHICLE IS EQUIPPED WITH AUTO LAMP YOU MUST USE TWO RELAYS, ONE ON PARKING LIGHTS AND THE OTHER ON HEADLAMPS. IF VEHICLE DOES NOT HAVE AUTO LAMPS THEN ONLY ONE RELAY IS REQUIRED AND THAT WILL BE ON JUST THE PARKING LIGHT WIRE.
SEE TECH TIP in link below;
http://documents.audiovox.com/701127.pdf
Hope it helps you with the install.

Dustin Wilson

• 96 Answers
• Posted on Feb 17, 2011

SOURCE: 2010 ford escape, total shutdown

first need to check codes, could be many diff. things, they had a prob. with wiring at the connectors (junction block) at right front of eng. near wiper cowl. and many other probs. , keep me in touch.

SOURCE: 2010 Dodge Nitro AC Fuse for fan location

First, it would be nice to know WHICH fan you are talking about. The engine cooling fan? The heater-A/C blower fan?

Second, this might be the time to educate you about fuses. Fuses do not cause electrical failures, Electrical failures cause blown fuses.

With that being said, it is highly unlikely that if you find the fuse you are looking for, that it will solve your problem.