SOURCE: isuzu trooper engine numbers
ok there are several places to look
the door panels stickers
the glove box
the engine compartment
manual
the engine number will be stamped on the block if facing truck it would be on the bottom right hand side between the first and second freeze plug
SOURCE: change a cv boot on a 1996 isuzu trooper
First their are two different front axles in 1996 troopers. Isuzu changed the 4wd system from auto lock hubs to drive control axle.auto lock hube are on the older trooper's with the light and wiper switches on the dash. The same way to change both. Auto hub remove the six hex. screws slide off the hub remove the sirclip from the driveshaft. Newer hub has 6 alan-head screw's again remove them then the hubcap then the sirclip on the shaft and slide off the round spacer. Next 4 bolts from the lower balljoint and the brake's. Pull out the hub until it clear's the shaft remove the inner boot clips slide the inner boot out the shaft. Clean the grease from the end of the axle then with your fingernail feel along any of the 3 tracks in the axle and near the outer end of the track you will find a wirelike split ring slide a screwdriver under the ring and lever it off . Pull out the drive clean off the grease. You will see a sirclip on the end of the joint remove it and slide off the joint. You can replace either boot from that end. The outer joint is held on with a snap ring on the shaft inside the joint and is not easily removed need a hammer and drift to drive off the end and when removed its hard to get the snap ring on the shaft back into its place.You can change both boots from this end as well. Cheers
SOURCE: timing mark's on isuzu trooper 3.0 td
The cam pulley notch goes in line with the mark on the front cam bearing cap and the crankshaft pulley goes at 12 o'clock - its got a tiny mark on the back lip that lines up with the mark on the cover .
Did you take the cams off in one lump or split them ? if you did come back on here for how to time them up .
SOURCE: isuzu trooper 2002 RLV engine. camshaft timing
Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.
Click on the following direct Link. It has the Timing Belt Diagrams and Photos with Marks for the Camshaft and Crankshaft that you will need. It also has numerous other helpful diagrams, instructions and photo's for use.
Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/2002/make/isuzu/model/trooper/2002_isuzu_trooper_timing_belt_diagram_marks.htm
SOURCE: 4jx1 camshaft marks on isuzu trooper 2001 3,0 dohc
the timming gear that the belt runs on has a mark (V cut in gear) to rear cover at about 12 o clock and crank pulley has timming mark for top dead centre, both cams have cut outs in rear that a special tool (camshaft stopper 5-8840-2592-0) locks into to hold cams in correct position, but can do without this, if the cam belt gear is off, the keyway should be at 12 o clock. the marks in the camshaft gears (dots) is for assembly of sissor gears to solid gears on camshafts that run together and they should match up only if you had this appart.
no.1 is timming mark
this is the locking plate tool
318 views
Usually answered in minutes!
×