My 2000 chevy venture died while driving. The battery is fine and will not turn over.

SOURCE: 2000 chevy pick up died while driving and won't restart?

check the crank angle sensor

SOURCE: transmission

Well ,

If the fluid is dark, burnt , or has metal or dark clutch material.
The transmission has a burnt up clutches ,the sun shell in most cases with this transmission is the cause of failure inside.The sun shell holds the clutches and steels in place . When the sun shell breaks the transmission is loosing pressure inside. Then the clutch are not engaging . This is why the transmission is slipping This is a very common problem with this vehicle. The sensors/ soleniods are located in the valve body of the transmision. There are some cases where a transmission shop can tighten the sun shell or bands. This could be a temporary fix, The best thing to do is have the transmission replaced or rebuilt at your local transmission repair shop

Dale Farr

• 78 Answers
• Posted on Mar 17, 2009

SOURCE: the security light is on in my 2001 chevy venture message center

Hi there,
Most commonly with these cars the security system will do this if the battery is "drained" while trying to start the car. ie: a low battery that is too weak to turn the engine over. Usualy the power options & accesories will not work if this is happening.
To fix it you will need to ensure the battery is charged, you then disconnect the battery negative cable for about 1 minute with the key out of the ignition. reconnect the battery cable & start the car normally. Everything should be back to normal.
Let me know if there is anything more you need for this concern.
Farrout!

SOURCE: jump start 2000 venture

In order to reach the negative terminal to the battery in a 2000 Vebture (I have one) you must first remove the fuse housing. The fuse housing is a large black box that sits atop the battery. There os a single bolt that holds it in place located in fron of the battery bolted into the lip of the motor bay. Unscrew this, then unhook the fuse housing from the cross bar running from the back roght to the front of the motor bay. This is a tight fit so watch your knuckles. Once the fuse housing is out, the negative terminal is located on the backside of the battery. It is a tight squeeze black is negative, red is positive.

SOURCE: how do you reset power sliding door on 2000 chevy venture

there should be information in your owner manual telling you how to do it if you have miss place your owner manual try this website to see if you can down load one for your car its www.edmunds.com and i hope i was able to help you Michigan Man