SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1
It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.
SOURCE: camshaft position sensor location
At the right rear of the engine under the intake manifold and to the left of the oil filter. You will probably need to go under the car to spot it, it's the sensor with a three-wire connector arranged vertically. But you can take it out from above. It's held in with a single bolt with an eight MM head located just above the sensor. Un-clip and remove the electrical connector. Unscrew the bolt with a socket wrench & extension bar. Wiggle and pull the sensor out.
here is a picture.
SOURCE: Camshaft Position Sensor Location
IF U GO TO THE RIGHT SIDE OF THE ENGINE AND LOOK 4 INCHES BEHIND THE BELT IT WILL BE ON TOP OF THE TIMING COVER.THE WIRES WILL BE RED/WHITE,BLACK,BROWN/WHITE
SOURCE: where is the camshaft position sensor located on a
Click on this link to view the diagram. The sensor is #421 on this diagram. http://www.compnine.com/largeimg/060209TS00-410.gif
for starters you should have set your number one piston at top dead center (TDC) before you just changed the sensor, All it need is to be one or two teeth out on the timing chain to run rough, here is a link to a guide on how to solve this problem , I hope it helps:
ww2.justanswer,com/uploads/JHoop/2010-12-22_125719_1.pdf
2,568 views
Usually answered in minutes!
×