SOURCE: After Market radio install on a 2001 Passat
Metra makes a preamp harness that you can use if you have the partial Bose system. My A4 had that (where the front speakers were run off of the headunit with speaker-level feed, but the deck put a line level signal to a rear amp to power the speakers). This harness would let you use the aftermarket deck with your factory speakers, if you have the partial Bose system. Best bet is to do a Google search for "Metra 2001 Passat" or something like that and I'm sure it'll show up.
SOURCE: radio dont work fuse is good is there another fuse
Yes, but there is also a fuse stuck in the back of the radio itself.
SOURCE: NEED A RADIO CODE FOR A VOLKSWAGEN PASSAT 2001
Phone VW and give them the vin number of your car and they will give you the code for the radio
SOURCE: 2001 Passat Gauge Cluster Stopped Working (MPH, Tach, Oil, Temp)
if they have all stopped working but you still have the usual warning lights then the cluster will need changing
SOURCE: power windows not working on a 99 Passat
Hi,
The door panel comes off with a T-10 torx or a Hex (Allen) wrench that will fit and a large Philips Screw Driver..
Remove the Plastic cover on the inside Door handle and the screw or screw along the bottom of the door panel.
Then remove the screws that hold the handle the the door.They are located behind the plastic plate you removed with a tiny screw driver earlier. Be careful not the mark up the cover whaytprying it up. It is best to pry from underneath. After this 4 screws are out . The Use of a clip tool is best for getting behind the panel to pop it off, screw driver will work.
After all the clips are released. Pull the light at the bottom of the panel down and out. Disconnect it or push it back thought the hole it came from. Now you need a 10mm socket, or wrench to remove the 12 bolts that hold the metal plate to the door. Remove all the 10mm bolts, if the window has not already fallen in the door it should be released by removing the black 2" plugs. Then loosen the bolts that clamp the window with the arms. Do not loosen them all the way.Disconect all the wiring. The Door lock cable,can be a pain. I think it pulls down.Next remove the metal plate,that is the regulator. Reverse these steps again to install it.
thank you !!
218 views
Usually answered in minutes!
×