Where is the fuel filter located on a 2016 4010 4x4 mule it acts like it doesn't get enough fuel

https://www.youtube.com/watch?v=ghPIeS1AWfQ

https://www.youtube.com/watch?v=tkbYWEqK1MQ

For most late-model Mule™ side x side, the VIN is located on the forward frame rail below the seat. For all Trans4X4® models, the VIN is on the left rear driver seat frame rail, and Mule™ 600/610 4X4 models have it on the frame rail below the seat over the fuel tank. On most older Mule models, the VIN is near the front of the vehicle

The regulator is probably under the intake manifold along with your injectors...the pump is in the fuel tank and the filter is usually on the firewall...

You Vic?

It could be a clogged fuel line or fuel filter. Add a fuel additive first it could be gunk on the fuel injectors.

FUSES RELAYS LOCATED UNDER DRIVERS SIDE DASH BOARD.

Check your running fuel pump pressure. If (as I suspect) it's too low, first try changing your fuel filter. After changing the filter, recheck the running fuel pump pressure. If still low, check you fuel pump pressure regulator. If OK, you may need a new fuel pump.

Also probably would be a good idea to replace you air filter.

Good luck!

you can be getting fuel but it has to be enough pressure to operate injectors. this can only be determined with a gage..does it fire if u spray starting fluid in the intake and crank ? if so u havent enough pressure from pump.

ITS LOCATED ON THE FIREWALL NEAR THE STEERING COLUMN

autozone.com says filter is:
Under vehicle, passenger side, below seating area, front of fuel tank, mounted on frame in fuel line