SOURCE: Crankshaft Position Sensor and Camshaft Position Sensor
REMOVE OR DISCONNECT
INSTALL OR CONNECT:
SOURCE: I have a 2000 buick lesabre. The fix engine soon
It NEVER was the camshaft sensor! Unless, you've removed the engine lately, which I doubt.
RUN to Advance Auto Parts and buy a can of "SeaFoam" and add to your gas tank per instructions...drive at least 100 miles and the problem should go away...IF it doesn't you'll have to replace the O2 sensors in the exhaust system...Any good mechanic should be able to do this for much less $$ than the dealership DO NOT go to the dealer for repairs!
Good Luck
SOURCE: where is camshaft position sensor located on 3.1l
HI. Your CMP will be located, just below the cam cover gasket rail, in front of the cam carrier.
SOURCE: i need to change the camshaft position sensor for
well I dont know that car, but if you know where the camshaft is (middle of the engine) look where the front cam gear is. Its got to pick up a signal from the gear/magnet.
SOURCE: 2012 buick verano transmission lag
Tell dealer to do a trans flush with a TECH II and reset the trans adapts and should be good, this is all done by a electronic tool called a Tech II
Testimonial: "Your answer was helpful when I asked GM Buick div. for a solution. They are getting back to me after Easter. Will let you know what they say."
2,291 views
Usually answered in minutes!
×