How to replace outer brake light on 2001 mazda millenia

SOURCE: 2001 Mazda Millenia ignition switch / steering wheel locked

The tumblers have wore down and won't let the key turn. At this point you need to have the tumbler set replaced.
God Bless You Greg

scott rimmer

• 162 Answers
• Posted on Feb 27, 2009

SOURCE: oil leak

could be anything from description im fraid, if i was to tell you that if the top of yur engine is full of oil in the connection to the cylinders then it will prob be rocker gasket, however if the oil is coming out of the bottom of the engine then you might have sump gasket probs or sump plug malfunction, or worse case scenario oil seals for one of your external pumps. sorry i couldnt be more specific.

SOURCE: mazda millenia problems

here are a few problems to look out for:

Check-engine light: Check engine light comes on due to carbon buildup on the exhaust valves of 2.5L engine. (1995-02)

Engine noise: Some engines make a metallic tapping noise requiring a new friction-gear spring on the camshaft. (1995)

Headlights: The headlight drain hoses can get kinked by the aiming screws causing fogging. (1995-96)

Keys: It may be hard to turn the ignition key because the steering shaft is not positioned correctly. (1995)

Steering problems: The steering wheel may be off center requiring adjustment of the tie rods. (1995). You can also have a look at the following website where some owner have given their opinions on owning one. http://www.carsurvey.org/reviews/mazda/millenia/r68654/comments/

SOURCE: my hold light is flashing in my 2001 mazda millenia

hold light flashing means you have a transmission fault of some kind, check vehicle speed sensor

SOURCE: check engine light flashing on 2001 Mazda Millenia

You need to have a computerised car diagnostic done to the car.This will tell you the error code and what is causing this problem.Remember to always reset the car if there has been any replacement parts.Hope this helps.