SOURCE: check engine light and how to diagnois and reset 1999 Hyundai Sonata
I had same problem and my repair shop just replaced a sensor in the tranny. Said it was a defect by Hyundai,but they won't recall it.
SOURCE: headlights for 2006 hyundai sonata
Answer
1. Remove the dust cover from behind the bulb that needs replacement.
2. Unplug the bulb.
3. Taking note of the bulb orientation, unhook the bulb retaining clip from the tang that holds it in place.
4. Remove the bulb.
5. Install the new bulb in the same orientation and clip in place.
6. Reconnect the electrical connector to the bulb.
7. Reinstall the dust cover.
Alternatively, if the bulb is burned out and you have less than 60,000 miles, you should take the car to the dealer and let them do it for free for you.
SOURCE: Headlight bulb replacement for 2002 Hyundai
http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%090900c15280213e7e&subtitle=replace
SOURCE: '05 Hyundai Sonata Coolant Change
remove the cap on the radiator or the header tank, use a plastic container that will hold about 4 ltrs of coolant, there should be a drain tap at the bottom of the radiator, if not you have to remove the hose clamp on the bottom hose and let the coolant drain out.
Replace the hose and clamp, top up the radiator and run the motor while checking the coolant level, if the level goes down a bit just top it back up and check over the next day.
hope this helps
SOURCE: How do you change the cabin air filter in a 2009 Hyundai Sonata?
I just did this on our 2007 Sonata. 1. open the glove box. On both sides of the glove box, there is a black tab which prevents the glove box from opening to far. The Chilton manual says to remove these, but that is more difficult then simply pressing inward on the sides of the glove box to release them from the channel. Now the glove box should open even more. Next, remove the piston arm from the right side of the glove box. You can do this by removing the panel on the side of the dash, but you first need to open the passenger door. You can also just use a screwdriver or other tool to slip the piston of without removing the dash side panel. Now with the glove box hanging fully open, you can see the cabin filter box. There are tabs on both sides of the front that you simply press together in order to slide the filter out of the box. This whole process from beginning to end should only take about 10 minutes and is very simple.
390 views
Usually answered in minutes!
×