2003 ford escape xlt drum brake repair

SOURCE: removal of rear brake drum 2002 ford escape

make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off

SOURCE: How do you change serpentine belt on a 2003 ford

Rotate the accessory drive belt tensioner (5)clockwise and remove the accessory drive belt.

SOURCE: Brake drum 2005 Escape

here is a diagram on how to remove your brake drum. please do not forget to rate and comment about your experience with fixya today.

Removal & Installation
CAUTION Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.

1. Before servicing the vehicle, refer to the Precautions Section.
   
2. Remove the tire and wheel assembly.
   
   CAUTION Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.
   
   NOTE If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
   
3. Remove the brake drum.
   
4. If equipped, remove the brake drum retaining clips.
   
5. If the brake drums will not come off, follow these steps.
   
6. Move the brake shoe adjusting lever off the brake adjuster screw.
   
7. Loosen the brake shoe adjuster screw nut by adjusting the nut upward.
   
8. Using the special tool, 134-R0191, measure the brake drum inside diameter.
   
9. Install a new brake drum if the maximum inside diameter exceeds the specification shown on the outside of the brake drum.
   Drum brake exploded view
   

1. Clean the wheel hub mounting surface and wheel pilot.
   
2. Install the tire and wheel assembly.
   

Mike Butler

• 6674 Answers
• Posted on Sep 02, 2009

SOURCE: diagram of 1993 ford f-150 xlt rear drum brakes

This may help, if not let me know.

SOURCE: 2005 ford escape 3.0l AWD XLT - DRIVESHAFT CARRIER

if there is some one in your area that balances driveshafts they can change just the bearing for you