How to change high beam headlight on 2004 Buick rendevous

SOURCE: low beam headlights not working on 2004 Pontiac Montana extended

You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

SOURCE: 97 buick headlights go out

where is the relay headlight switch located on a 1998 buick century

Marvin

• 85242 Answers
• Posted on Sep 09, 2009

SOURCE: 99 buick century headlights

u changed the multifunction switch or the main head light switch?

SOURCE: Low Beam headlights not working.

Possible relay fault,also a burnt dimmer switch will cause this symptom

SOURCE: 1998 buick century only high beams and turn

The Buick Century is equipped with a multi-switch. This switch is an all in one switch that controls your cruise control, windshield wipers and turn signals in one switch. This switch also controls dimming and brightening of your headlights. The dimmer switch is simple to replace, and all you need is a phillips head screwdriver to complete the task.

1. Removing the Steering Column Shroud
   • Removing the dimmer switch starts at the steering column. To plan this task out, access the steering column by removing the screws holding the steering column shroud in place. This will expose the turn signal lever. Remove the lever by twisting it forward, and pulling it out of the switch.
     
   Removing the Dimmer Switch
   • The switch is held on by two screws and a wiring harness. The wiring harness can be removed by prying up on the locking tabs and pulling the connector out of the socket. The two screws can be removed with a phillips head screwdriver. The switch will slide out. To install a dimmer switch, be sure to repeat these steps in reverse order.