2001 chevy cavalier coil pack how to change it

SOURCE: How do you change the headlight for a 2001 chevy cavalier

i actually just did this a couple days ago, this takes about 20 minutes and a little bit of patience. When you pop your hood you will see a protective piece of plastic over the headlights/radiator, you firstly have to remove the plastic clips holding that piece then pull that piece of plastic off, once done u will see 2 bolts holding each headlight in place, i believe it is a 9/16 socket but if not just find the one that fits, remove the 4 bolts (2 for each headlight) and pull the headlight in an up and outwards manor. if you feel any resistance do not yank look at why it is catching and clear it, then it should just pop out (the headlight and the corner piece and clipped together so dont pull it too far out) then when the bulb is accessible pull the old bulb, put the new bulb in and voila place the headlight back into position, redo the 4 bolts holding the headlights and re-attach the plastic headlight/radiator cover. Enjoy the new lights

SOURCE: My 1991 cavalier z24 with 3.1 will not start, has

Can you unplug one of the injectors to check for injection pulse. You should be able to unplug number 1 (next to the alternator) and number 6

Jason Phillips

• 500 Answers
• Posted on May 18, 2009

SOURCE: coil pack diagram?

cylinder 1 is on passenger side, coils should be numbered, cylinder 4 is on drivers side

SOURCE: Replacement of Water Pump. 2001 Chevy Cavalier 2.4 L

Stick with me on this
1.Put the car on jack stands
2.Remove the exhuast manifold, Do not rotate the flex cuopling more then 4 degrees od damage will occur.
3.Diconnect the coolant inlet pipe from the water pump outlet hose, Disconnect from the engine, disconnect it from the thermostate housing and remove it.
4.lower the car back down of the jack stands.
5.Detach the brack booster hose.
6.Remove the timing chain cover and the tensioner.
7.Remove the heater outletpiper from the water pump.
8.Remove the water pump cover bolts.
9.Remove the water pump retianer nuts.
Remove the old gasket and clean.
10.On bench. Install the waterpump and cover but lreave the bolts finger tight.
11.Install back in car, leave water pump bolts looseto allow for positioning.
12.Install water pump cover to engine, tighten by hand.
13.Lubricate oringand install metal outlet pipe back into pump, hand tighten.
14a.Tighten the water pump to timing chain nuts
14b.Tighten the water pump cover to water pump housing bolts.
14c.Tighten water pump cover to engine block bolts.
14d.Tighten the radiator outlet pipe to water pump.
15.Install timing chain tensioner.
16.Install exhuast manifold.
17.Install exhuast pipe.
18. Fill it up and bleed the system.
Good luck

SOURCE: 2.2 ecotec engine. Code says random misfire. What

did you fix it? if you did what did you do? i have the same prblm thanks!