I need torque settings for my Hyundai elantra 1.6 gls 1995 cylinder head bolts

Head bolts are torqued in 3 steps, 1-18ft.lbs, 2-60 degrees, 3-60 degrees, camshaft caps-10-11 ftlbs, intake manifold-12-17ftlbs, exh manifolds-32-40 ftlbs, camshaft pulley-74-89 ftlbs.

See the settings here:
http://www.autozmagz.com/search/hyundai+getz+cylinder+head+bolt+torque+settings

Follow these steps to adjust to the recommended torque:
1. cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
2. mains-30nm +65deg
3. big ends- 1 - 26nm 2 - 52NM
4. fly-wheel -130nm
5. cam-sprocket - 100-120
6. crank-pulley - 170-180
7. cam caps -15nm

cylinder head bolt torque

10 mm bolts

step 1 22 ft lbs
step 2 additional 60 degrees
step 3 additional 60 degrees

12 mm bolts

step 1 26 ft lbs.
step 2 additional 60 degrees
step 3 additional 60 degrees

exhaust manifold nut 32-41 ft lbs.

intake manifold nut 11-15 ft lbs.

rocker cover 71-86 in. lbs.

Revised Bulletin
This TSB supersedes the Cylinder Head Bolt Torque Specifications previously described in TSB # 96-20-003, TSB # 96-20-003-1 and TSB # 97-20-004.
DESCRIPTION:
This bulletin provides torque specification corrections to the 1996 and 1997 Elantra Shop Manual, 1997 Elantra Service Data Book, 1997 Tiburon Shop Manual and 1997 Tiburon Service Data Book.
Please record the corrections (listed) in the appropriate manuals and write the TSB number on the bottom of the pages listed below for future reference.
CYLINDER HEAD BOLT:
(M10) 30 Nm (300 kg.cm; 22 lb.ft) + (60°to 65°) + (60°to 65°)
(M12) 35 Nm (350 kg.cm; 26 lb.ft) + (60°to 65°) + (60°to 65°)

You have two bolt sizes the shorter or smaller of the two sizes is called M10 the torque is 22ft lbs +65 degrees +65 degrees again The larger of the two bolts is called a M12 the torque for these are 26ft lbs +65+65. There is a tightening order staring at the top center bolt and working in a circle They have to be torqued in three steps. If you dont under stand something about this repost and I can help you farther. If this is helpful please mark that it was I do this for free to help people DRIVE SAFE TIM

The cylinder head bolts need to be torqued at

• 10MM bolts 22 FT-LBS
• 12mm bolts 26 FT-LBS

dear friend:here follows the settings in need:
cylinder head-30-35 nm + 30-35 + 65deg + 65deg.
mains-30nm +65deg
big ends- 1 - 26nm 2 - 52NM
fly-wheel -130nm
cam-sprocket - 100-120
crank-pulley - 170-180
cam caps -15nm

1st stage 45lbs then 65 then 85