7\99 Lincoln Town car LF window down won't go up

SOURCE: 1994 town car rear windows will not open or close

Try checking the fuses and circuit breakers for the power windows first, if there good then it could be the the rear window lockout switch, check for continuity in the unlocked position. If it does'nt have continuity replce the switch.

SOURCE: power window control

So as not to be repetitive, for the failure of your power driver side window and rear window, review this handy diagnostic article, which identifies the possible causes, from a bad fuse, relay to window motor, etc.:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Windshield_Windows_Window_Does_Not_Roll_Up_Down.htm

This should help narrow down your particular cause.
Brad

SOURCE: Lincoln Town Car 1999 driver side window switch

I have the same problem in my 2001 towncar. I removed the switch control panel (without removing the door panel) by prying up from the front of the panel. There's a spring loaded plug under the mirror adjustment. Once you get that pulled up, the whole unit will lift out. Since there's a two year difference in the models - it MAY not work... however, you might not have to remove the whole door panel as you think.
In my case, the wiring was bad.

SOURCE: 99 lincoln town car wont start?

make sure both plus amd minus turnimals are tight loss conection wont start the car you might get a clicking or just nothing

SOURCE: 2003 Lincoln Town Car - Power window switch removal/installation

SECTION 501-05: Interior Trim and Ornamentation 2003 Town Car Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/28/2002 Front Door Trim Panel Printable View (206 KB) Removal and Installation
NOTE: LH side shown, RH side similar.

1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.

1. Remove the window switch plate.

1. Disconnect the electrical connectors.

1. CAUTION: Use care not to damage the trim panel covers.
   Open the screw covers.

1. Remove the screws and the assist handle.

1. Remove screws and the front door trim.

1. Disconnect the electrical connectors.

1. To install, reverse the removal procedure.