Cars & Trucks Logo

Related Topics:

G
Gordon marks Posted on Mar 29, 2017

I have a 2009 gmc sierra and the fenders on back are rusting bad this shouldn't it only has 168 km

4 Related Answers

Anonymous

  • 51 Answers
  • Posted on Aug 27, 2009

SOURCE: how do i remove a fender off of a 1993 gmc sierra?

under the bonnet there will be some 10 mm bolts running along the top of fender and one under fender near bottom of the door and take the headlight out and there will be 2 or 3 there

Ad

Anonymous

  • 880 Answers
  • Posted on Jan 04, 2011

SOURCE: I have a 2009 gmc sierra 1500 and I believe my

I think it is located on the firewall on the passenger side of the vehicle. It is directly below thae passengerside windshield wiper. Look for a plasctic cover with writing on the top such as "Power block" or "Fuel pump relay" or "Fuel pump Fuse

cy schousboe

  • 2002 Answers
  • Posted on Jun 24, 2011

SOURCE: Tires cupping. Service adviser at

Not necessarily. You will have to read the fine print in your warranty. If the warranty doesn't cover maintenance items then you are out of luck. Maintenance items usually include brakes, tune ups, oil changes, tires, etc., things that normally wear quickly. Suspension could also be considered a maintenance item because there are many factors involved in determining how long it will last before you need to start replacing suspension parts, none of which the factory has any control over. They can be held accountable if there is a flaw in the suspension such as a manufacturing defect or design flaw, but that's about it. They can't control how you drive or load the car. Bad roads (potholes,bumps) or heavy loaded or overloaded cars dramatically shorten the life of suspension. Driving habits can also factor in, especially in conjunction with one of the other two.
You would have to prove to them that it's not your fault before they would consider doing anything about it if the fine print eliminates maintenance items from the warranty. If the fine print doesn't then you will have to argue the specific parts of the warrant that you think apply to your situation. Hope this helps.

Vernon Taylor

  • 7446 Answers
  • Posted on Sep 25, 2016

SOURCE: How to reset abs light 95 gmc Sierra km 4x4

Often once the fault that caused the light to switch on has been cured the light will go out. If it doesn't either the fault(s) haven't been fixed or diagnostic equipment will be needed.

A few early abs vehicles might reset by disconnecting the battery for a while

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2009 GMC Sierra 5.3. What could be the cause of my Stabilitrack going on and off for no reason and making my truck run bad?

Question edited for clarity.

You need a good auto electrican with a $5,000 pro grade scan tool computer to diagnose. Your issues are electrically caused, not mechanical. 'Local mechanics' don't buy the fancy scanners.
0helpful
1answer

Why is gas leaking from the metal elbow that leads to the cap on top of fuel tank?

It has rusted threw. Replace the filler tube or use silicone to plug the hole. Not to much though, you don't want to plug that line. It is a vent.
0helpful
1answer

Replace cabin air filter 2009 gmc sierra

As per the attached pictures in GMC Sierra 2009 I can't find any access to the AC filter!
Doesn't have one?
8_11_2015_4_31_25_pm.jpg8_11_2015_4_31_26_pm.jpg
0helpful
2answers

I have a 2009 gmc sierra 1500 and I believe my fuel pump relay is bad, however, I can't seem to locate it on my truck. Could you please help?

I think it is located on the firewall on the passenger side of the vehicle. It is directly below thae passengerside windshield wiper. Look for a plasctic cover with writing on the top such as "Power block" or "Fuel pump relay" or "Fuel pump Fuse
0helpful
1answer

HOW TO FIX A GAP BETWEEN FENDER AND DOOR ON 1989

loosen the bolts and move fender back a little bit then tighten the bolts when the fender is where you want it.
0helpful
1answer

How do i remove a fender off of a 1993 gmc sierra?

under the bonnet there will be some 10 mm bolts running along the top of fender and one under fender near bottom of the door and take the headlight out and there will be 2 or 3 there
1helpful
2answers

99 GMC Sierra Fluid Leak Immediately after Getting Oil Change

as an owner of three gmc sierras, i can attest that the brake lines that run along the frame rail under the master cylinder inherently rust away and break. I wouldnt neccesarily think it was tampered with. but do check the condition of all of the lines including the fuel lines for excessive rust.
0helpful
1answer

2009 GMC Sierra 1500 new add

The 2009 GMC Sierra adds a gas/electric hybrid model to its lineup. Sierra offers regular, extended, and crew cab body styles
if it really change the performance hard to answer it all about personal experience, buy it and try it
Not finding what you are looking for?

59 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...