SOURCE: 2002 Mitsubishi galant
Remove the drive belts, crankshaft pulley, and timing covers. Align the
timing marks on the camshaft and crankshaft and r+r the belt
SOURCE: galant rear wheel hub
remove your rear wheel then remove the brake assembly. there are 4 bolts that hold the hub to the rear axel with anti lock brakes you will have a wire to remove from the hub. it may tak a large hammer and chisel to remove the hub. but it will come off. then reinstall (if there is any shims behind the hub they must be put back in in the same directions (these are alignment shims) some have some dont. tighten bolts and test drive the ca 5 miles or so. then retighten the lug bolts. and then again after 100 miles.
hope this helps 
SOURCE: service engine light on 2002 mitsubishi galant
it could be the spark plugs, at least that is what it was for mine, if you have over 50k miles without a spark plug change i highly suggest one, also a oil /transmission change would be great for your car too if you haven't done those reciently. I would also suggest using a higher grade gas, sometimes this fixes the trick too.
If you try all those and still experiencing hard transitions please let me know and i'll try a more indepth analysis on your car.
Thanks jyotsna.
SOURCE: 2002 mitsubishi galant
Has it overheated lately?
My wife overheated our Galant and it just stopped working, it cranks but that's it.
I pulled the sparkplugs and found them wrapped in a gewey jelly like substance. Like an oil/antifreeze combo.
I am going to replace the entire motor for $1000 as taking it to the mechanics to theorize and practice may cost more.
SOURCE: why is my 2002 mitsubishi galant oil light comming on after highw
eigher bad switch or bad oil pump
118 views
Usually answered in minutes!
×