This is a lenghty job!! You would have to remove the plastic engine cover to locate the plugs (cover that has the lexus symbol). There are 3 coils(black squarish units) on the front head and another three in the rear head. You must remove these to access the sprakplugs. Front is very easy!! The rear is difficult, you would have to remove the intake(special tools are needed) to access the rear coils and sparkplugs. hopefully this helps
SOURCE: can't locate thermostat on 2000 RX300 Lexus
follow the big rubber hose from the radiator to the engine. the top readiator hos. If at the engine there is two bolts holding down the hose connection housing, You found iit. If not there, look on the block end of the lower host.
SOURCE: where is the ignition coil
the back plugs are under the intake plenum. Tey can be changed without pulling the plenum but for a novice it may be easier to remove the plenum. The fronts are under the engine cover that says v-6...3000..v v t i, etc. Remove that cover and you will either see three coils or three wires. The plugs will be under those.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: Replacing outer tail light on Lexus RX300 ?
Normal
0
false
false
false
MicrosoftInternetExplorer4
/* Style Definitions */
table.MsoNormalTable
{mso-style-name:"Table Normal";
mso-tstyle-rowband-size:0;
mso-tstyle-colband-size:0;
mso-style-noshow:yes;
mso-style-parent:"";
mso-padding-alt:0in 5.4pt 0in 5.4pt;
mso-para-margin:0in;
mso-para-margin-bottom:.0001pt;
mso-pagination:widow-orphan;
font-size:10.0pt;
font-family:"Times New Roman";
mso-fareast-font-family:"Times New Roman";
mso-ansi-language:#0400;
mso-fareast-language:#0400;
mso-bidi-language:#0400;}
Lift the hatch. The tall center light is located behind the
upper hatch inside panel. There are two
panels need to remove. One panel is on the right, the other on the left. To
remove the panels you have to use flat screw driver to pry out the panel in
several locations. (These panels are secured by several small metal clips.) Be
careful to collect all these clips and replace them on the back of the panel.
You will need these clips to replace the panel later on. After remove the panels,
you will be able to locate the screws on the tall center stop light assembly. Remove
those screws and cover. After replacing light bulb. Assemble everything in
reverse order. Remember, the metal clips have to set on the back of the two
panels not the car body.
1,741 views
Usually answered in minutes!
×