How do I change the driver side vent cover on my 06 grand prix

SOURCE: 1998 Pontiac Grand Prix A/C Blows hot on drivers side coldeer on passenger

i have an Idea. first of all make sure that all of your vents are not plugged up. next check your heating coils to find out if only one side is hot or the other is only cold. i need more info

SOURCE: Pontiac Grand Prix 98

When the window is not used often or gets a little older the motor can "Hang Up" You might try having someone hold the down switch on the drivers door while you slam the door. This will sometimes jar the motor enough to make the brushes contact and start working.

SOURCE: 1998 grand prix no heat on 1 side

thats most likely what it is. either that, or something has fallen down the defrosters and its blocking the blend door from opening or closing

SOURCE: Installing exterior driver side and passaner side door handles

I found this on another page, hope it helps:)

Remove the plastic cover behind the door handle assembly by removing one black 14mm nut from just above the door handle, and 1 screw (usually phillips) from the bottom of the plastic cover.
Remove linkages from lock cylinder and door handle assembly. Use a small flathead screwdriver to slide retaining clips forward, and linkages will come free.
Remove one black 14mm nut from the very top of the door handle assembly.
Remove one phillips screw drom the bottom of the door handle assembly.
Door handle assembly should now come free by pulling out slightly at the top, and pulling upwards.
Transfer lock cylinder and key minder light (if applicable) to new door handle assembly. Lock cylinder is retained by a single TORX bolt.
Reinstall in reverse.
TIP: If you lose or damage any of those black plastic coated nuts, order new ones. They are GM p/n 10067214 and should be around $0.58/each. There are two on each door.

SOURCE: how to change light bulb in the gear shift of 06

Remove the center console.
There will be a bulb underneath the PRNDL(Park, Reverse, Neutral, Drive, Low) - quarter turn to the left. Pull bulb down; put new bulb in - put back in hole quarter turn to right - reinstall center console...