Where do wires for 2000 blazer power drivers seat run?

It will either be the switch or the motor itself.

Can You Pick Up Another Seat From A Salvage Yard?

I wouldn't ruin anything by trying things yourself

I would have a dealer check it out

The dealer I used in the past, has a seat specialist come
in on Wed only, around 5:30 after the service bays close
& one service writer hangs out until that person fixes a
couple vehicles seat issues

SOUNDS LIKE THE MOTOR IS GOING OUT,BECAUSE AT LEAST ITS MOVING,I WOULD REPALCE REPLACE THE MOTOR,GOOD LUCK!!!!!!!!

only 4 bolts hold the seat in they may have a plastic cover on them that can be popped off with a screwdriver.remove the bolts and lean the seat back check the wires going to the motor and make sure it has power going to it.Don't know of any way to manually recline the seat without taking it apart.

The guy that posted the first solution...that works...My power seat module went bad , so I used a 12 volt batery charger on the wires to move my power seats.

where is the overload protection circuit for power seat of nissan altima 2001 , the seat does not move back and front let me know if i could do the seat move

Because that switch is broken and stuck in the recline mode.

Motor on the seat may have gone out, contacts in switch got dirty or worn, or assembly reached limit and stuck. Try sitting in it pushing back hard and adjust. If not youll need to replace switch,b take seat apart to fix or replace.

The seat position is changed through the use of a cable that runs through a flexible tunnel, under the seat. In one case that I'm aware of, this cable got stuck around a projecting seat spring under the seat. When the seat was reclined and moved backward or forward, the cable caught on the seat spring and the seat had insufficient slack in the cable to release from the reclined position.