How much does a camshaft Phaser cost with labor for a 2005 Nissan Xterra

SOURCE: How do you remove the radio from a 2005 Nissan Xterra?

the dash around the radio needs to be pulled off. Be carefull doing this so the plastic clips are not damaged. There may be screws as well, that you can see from the underside ( looking from the floor to the roof)

SOURCE: 2005 Nissan Xterra gas gauge reads empty when full of gas.

My car won't start.I put the key in the ignition, turn the key and nothing happens. It's not the chip in the key, I tried a new key. I usually have to wait about 5 min. then it starts up like nothing is wrong.

HyeProfile

• 35 Answers
• Posted on Aug 05, 2009

SOURCE: sensor locations

Here's the diagnostic procedure for DTC code 0340, directly from the service manual:

Marvin

• 85242 Answers
• Posted on Nov 10, 2009

SOURCE: replace transmission in 2005 nissan maxima

ABOUT 4-6 HOURS OF LABOR, DEPENDS ON WERE U HAVE IT DONE..

Testimonial: "Thank you, thought it was about 7."

Barry N Melissa Spring

• 230 Answers
• Posted on Mar 31, 2010

SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA

Removal & Installation

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Drain the fuel tank.
4. Remove or disconnect the following:
   
   Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump
   

1. Install or connect the following:
   
   Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
   
2. Fill the fuel tank.
3. Start the engine and check for leaks.