SOURCE: honda accord 96 exi
You need to discharge the AC system and remove the evaporator to replace the
expansion valve. No two way about it.
No need to remove the dash
SOURCE: 1992 Honda Accord LX won't start - ignition problems
you have to replace the main relay located inside the car, its located underneath the cruise control module, on the drivers side
SOURCE: 1995 honda civic d15b7 cranks but wont start. new
Are you sure you have correct timing? its definetly a fule problem, if timing is good then turn your key to the on position and try to listin for the fule pump to prime. While the key is in on position go to fuel rail, there is a valve on fule rail called sharader valve. Get a small screw driver and press valve in to check if car has fule pressure. if pressure is present then it is incorrect timing or possible bad cam sensor.
SOURCE: 1996 Honda Accord Rough Idle Even After tune up
Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps
336 views
Usually answered in minutes!
×