SOURCE: nissan murano 2005 sl keyless entry remote programing
Close all vehicle doors, LOCK doors using drivers side switch.
Insert key all the way into the ignition, (do not turn) remove key.
Repeat this step 5 times. (6 total)
Hazards should flash to indicate program mode.
Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.
*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press
any button on remote, hazards should flash. Repeat step as necessary.
Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.
Source
SOURCE: 2004 Nissan Murano How do you clear maintenance light after oil change?
press maintanence button until you see engine oil, then hold trip/reset button... :)
SOURCE: 2005 nissan murano sl, with rattling sound when accelerating
I recently experienced the same symptom with my '05 Murano and it was not a fuel problem. The dealer listed the cause as dry axle splines and replaced both front drive shaft assy's. Note that this was done as warranty with no cost incurred by me.
SOURCE: Replace rear wiper on 2005 Murano
You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.
The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:
SOURCE: how do i reset my check engine soon light 2005
you can buy a code reader from an auto parts store that will give you the ability to reset the check engine light, or most parts stores have one that they use on customers cars at no charge. if you ask them to read which code your car is throwing, most of them will let you hit the button to clear the code. they aren't supposed to do it themselves for some reason, but from my experience they will let you.
166 views
Usually answered in minutes!
×