SOURCE: check engine light code p1603
When I went outside to start my Jaguar X-Type it was cold outside. I was in a hurry and didn't let the car warm up properly. It jumped a bit then the check engine light came on along with a message that said No cruise control. The no cruise light came off but my check engine light is still on. Any suggestions as to what it may be?
SOURCE: reset warning engine light
you can reset the engine warning light by taking the earth lead off the battery and connecting it to the positive lead, then switch on the ignition,. Reconnect the earth lead to the battery and the light will have been reset. What you are doing is discharging the diagnostic chip to earth, which is exactly what the jaguar main dealer equipment does.This works on all cars.
PLEASE NOTE, make sure you disconnect the earth lead from the battery .
SOURCE: How to reset the engine light on jaguar 200 s
Have you tried disconnecting the negative battery cable for about thirty seconds.
SOURCE: 2003 Jaguar S Type R 4.2L SC. Check engine light
Rent a scanner, read out any code(s), and pursue to repairs. It may be as simple as bad spark plugs and wiring, or worse, fuel problems from the injectors back to the fuel tank. A worn O2 sensor can cause improper fuel/air problems.
SOURCE: 2005 Jaguar X-type p1796, p1797 fault codes -
both of these codes refer to the transmission,it is now in LIMP HOME MODE,the codes refer to open or shorted circuits in the CAN (controlled area network) the computer system in the car. check for blown fuses first,then have the car scanned with a european scan tool which is capable of bi-directional communication with the vehicle,get back to me if you need more help,Please rate my fix as i strive to be the best Thanks Ray
1,519 views
Usually answered in minutes!
×